Preparation
Basic Connections
This section explains all connections needed to make and receive IP line and TEL line calls.
•
To connect a Portable Station (PS) to the unit, see page 43.
•
To connect a computer to the unit, see page 45 or page 46.
A AC Adaptor Cord
B LAN Cable
C Telephone Cord
D To AC Outlet
KX-NT700NE/UK/RU/BX/ML: use the included AC
cord
1.
Connect the unit to the desired IP network and/or telephone line.
•
To connect to an IP network, connect a category 5 LAN cable to the LAN port and to a switching hub.
•
To connect to a telephone line, connect a telephone cord to the LINE jack and to a modular telephone
jack.
2.
Connect the AC adaptor cord of the included AC adaptor to the unit's DC input.
•
To use PoE (Power over Ethernet), connect the LAN cable to a PoE-compatible (IEEE802.3af)
switching hub or power supply. The included AC adaptor does not need to be connected when using
PoE.
•
If using an AC adaptor, use only the included AC adaptor.
•
Pass the AC adaptor cord through the groove on the bottom of the unit.
3.
KX-NT700C/AL/NZ: Connect the AC adaptor to the AC outlet.
KX-NT700NE/UK/RU/BX/ML: Connect the AC cord to the AC adaptor, then connect the AC cord to the
AC outlet.
•
If "Select Country" is displayed after the unit turns on, press [ ] or [ ] repeatedly to select the
country of use, then press
Document Version
2010/02
LINE
LAN
DC IN
A
B
C
.
SAVE
F
KX-NT700NE
KX-NT700UK
D
KX-NT700RU
KX-NT700BX
KX-NT700ML
E
G
E To Switching Hub
F Groove
G Telephone Jack or PBX
Preparation
D
Operating Instructions
23