Table of Contents
Advertisement
Step
Figure
9
10
11
5-3-5. White balance
Step
Figure
1
(1) Press [VSG] button and click [+] or [-] button to adjust the
signal level.
(2) Press [VGG] button and click [+] or [-] button to adjust the
signal level.
(3) Press [Next] button.
NOTE: Display image disappears when [VSG] button is
pushed.
(1) Press [VSB] button and click [+] or [-] button to adjust the
signal level.
(2) Press [VGB] button and click [+] or [-] button to adjust the
signal level.
(3) Press [Next] button.
NOTE: Display image disappears when [VSB] button is
pushed.
(1) Select a red single color screen when adjusting R. Click
[WM6] button, and adjust the flicker level to minimum in
both + and - directions, taking note of the data values.
Then set data to the mid-point between the two
previously noted values.
(2) Adjust other colors to be the same, using [WM5] for
green and [WM4] for blue.
(3) Click [Upside Down] button to change projection mode.
(4) Adjust this mode in the same way.
(5) Click [Next] buttons.
(1) Select "White Balance" step.
(2) Press [Start] button.
1-43
Explanation
Explanation
Advertisement
Table of Contents
