Table of Contents
Advertisement
Using the Tire Sealant and Compressor
Kit without Sealant to Inflate a Tire (Not
Punctured)
To use the air compressor to inflate a tire with air only
and not sealant:
If a tire goes flat, avoid further tire and wheel damage
by driving slowly to a level place. Turn on the hazard
warning flashers. See Hazard Warning Flashers on
page 4 3.
See If a Tire Goes Flat on page 6 68 for other
important safety warnings.
Always do a safety check first. See If a Tire Goes Flat
on page 6 68. Do not remove any objects that have
penetrated the tire.
1. Remove the tire sealant and compressor kit from
its storage location. See Tire Sealant and
Compressor Kit Storage on page 6 78.
2. Unwrap the air only hose (E) and the power
plug (G).
3. Place the kit on the ground.
Make sure the tire valve stem is positioned close to
the ground so the hose will reach it.
4. Remove the tire valve stem cap from the flat tire by
turning it counterclockwise.
5. Attach the air only hose (E) onto the tire valve
stem by turning it clockwise until it is tight.
6-75
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the HHR 2011 and is the answer not in the manual?
Questions and answers
where is the fuse panel and what type of fuse for windshield wipers?
The fuse panel in a 2011 Chevrolet HHR is located on the passenger side of the floor console behind the forward panel. The fuse used for the windshield wipers is located in position 15 and is protected by a fuse in the floor console fuse block.
This answer is automatically generated