Kenmore 10478 Use & Care Manual page 7

CONVERSION INSTRUCTIONS
Searing Burner Conversion
1. Remove screws at the back of searing
burner to detach it from bracket. Then lift
the burner while sliding it out of firebox.
(Fig. 8)
Fig. 8
Orifice
2. Insert the provided orifice removal tool (B)
into the burner opening and unscrew orifice
from end of valve.(Fig.9)
B
Fig. 9
B
3. Put the new orifice into the orifice
removal tool (B), and then insert the tool
into the burner opening and tighten the new
1.44
orifice to the valve.
Make sure you are using the correct orifice,
which is marked "1.44". (Fig. 10)
Fig. 10
4. Replace burner and screws. Make sure
The sear burner
to engage the tube over valve as shown.
(Fig. 11)
Fig. 11
7