Sony Cyber-shot DSC-N2 Service Manual page 14

Sony dsc-n2 digital still camera service manual

Hide thumbs Also See for Cyber-shot DSC-N2:

Table of Contents

2-3-4. INSTALL NEW ORNAMENTAL RING (A)

Apply a thin coat of adhesive to the inside of ornamental ring (A).

Note: Use adhesive (Super X) or an equivalent article.

Don't use what becomes white after drying like a quick-drying glue.

Ornamental ring (A)

From the top spring position, cover new ornamental ring (A) on the 1 group frame.

Rotate the ornamental ring (A) over 90 degrees to spread the adhesive.

Note: Adhesive must not run off the lens-barrel.

Stiffen by leaving it for 60 minutes or more.

Turn on and off the power to check the opening and closing of the barrier block with the camera in horizontal, up and down directions

respectively.

Further, check the zoom motion.

Rotate the ornamental ring (A) lightly to check that it is not removed.

DSC-N2_L2

Position of adhesive spreading

Note: Refer after the adhesive of the removed ring.

Wipe off when the adhesive adheres outside

or edge side on the ring.

Adhesive

0.1mm

1.5-2.0mm

Adhesive

Spring

0.5mm

Ornamental ring (A)

2-6

Table of Contents