Remove The Top Cover; Remove The Main Board - Motorola GTX/LCS 2000 Service Manual

Remove the Top Cover

Remove the Main Board

5-2 Disassembly & Reassembly
1. Insert a small flat blade screw driver in the side recess of the
radio chassis. Repeat the operation on the opposite side of the
radio.
2. Lift the top cover over the chassis.
Figure 5-3 Top Cover Removal
1. Remove the power and antenna connector retaining clips by
inserting a small flat blade screw driver between the clip and the
top of the chassis wall and gently prying the clip upwards.
2. Remove the 3 screws of the PA shield using a T8 TORX driver.
Remove the PA shield by gently prying up each corner of the
shield.
3. Remove the 8 screws securing the main board to the radio
chassis.
4. Carefully remove the main board by rotating it out of the chassis.
5. Slowly lift the board on the front edge, the side with the
connector that mates with the control head, and pull gently
toward the front of the radio.
CAUTION
!
The thermal grease can act as an adhesive and
cause the leads of the heat dissipating devices to
be over stressed if the board is lifted too quickly.
SIDE RECESS