Table of Contents
Advertisement
Manual transmission remote start
If the vehicle has a manual transmission the proper steps must be followed be-
fore leaving the parked vehicle or the remote start feature is disabled.
1.
Make sure the engine is running and the doors on the vehicle are closed.
2.
Put the transmission in neutral.
3.
Press on the brake in the vehicle.
4.
Apply the emergency brake.
5.
Release the brake.
6.
Within 15 seconds activate the remote start from the remote.
7.
The parking lights will flash 5-times confirming that the remote start is ac-
tive. If the parking lights do not flash 5-times, then repeat steps 1 - 6.
8.
Turn off the ignition (the car stays running when key is turned off).
9.
Exit the vehicle.
10.
Lock the system. (the vehicle shuts off when locking the system).
You can now remote start the vehicle. If a door is opened before the next remote
start activation the system will not remote start.
Note:
To enable Valet take-over with a manual transmission, open the door and
enter into manual transmission mode, as described above. The parking lights
flash one-time when entering Valet take-over. Once you exit the vehicle you can
lock the system and the car will remain running. If the vehicle shuts down when
locking, then the unit did not enter valet take-over mode.
60
© 2008 Directed Electronics. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 5301 and is the answer not in the manual?
Questions and answers