Important Notes; Power Cut During Ironing; Motor Protection; Feed-In Table Adjustment Range - Miele MM 50-175 Operating Instructions Manual

Important notes

If there is a power cut whilst ironing
Power cut during ironing with an on-site
compressed air supply
In the event of a power cut, the heater plate
is automatically withdrawn to prevent any
damage to the roller cover or the laundry.
The laundry can then be removed.
To switch the ironer on again press the h
Start button.
Power cut during ironing with an
integrated compressor
In the event of a power cut, the heater plate
is automatically withdrawn to prevent any
damage to the roller cover or the laundry.
The laundry can then be removed.
On machines with an integrated compressor
the automatic pressure release mechanism
has to be re-set before switching the
machine on again if the compressor was
running when the emergency stop switch
was activated.
First open the service panel in the right hand
side of the machine.
Press the black On/Off switch (next to the
pressure release coupling) in = OFF
and then pull it out = ON.
Close the service panel up again.
To switch the ironer on again press the h
Start button.
Operating and maintenance instructions
are supplied with the compressor.
16
Protection of the motor and the roller
cover
In pauses between ironing and when you
have finished ironing, withdraw the heater
plate. Not doing this can reduce the life of
the roller cover and of the motor.
It is very important to avoid running the
ironer without passing laundry through it.
Do not restrict ironing smaller articles to any
one part of the roller; make use of the whole
roller width. This way an equal amount of
heat is obtained from the heater plate and
the roller padding is protected from uneven
use.

Motor protection

If the winding is heated excessively due to
overload, the motor is switched off
automatically by a winding thermostat. The
heater plate is withdrawn. Once the ironer
has cooled down, it will need to be switched
on again by pressing the h Start button.
Feed-in table adjustment
The feed-in table has an adjustment range of
max. 14.5 mm.
M.-Nr. 05 567 240 /03