Sanyo HEC-FX1 Service Manual page 13

Replacement Procedure
(8) Replacement of Power Switch and
Current Fuse
1, Open a fuse cover of current fuse and take
out a current fuse.
2, Take off the cover (back cover).
3, Take off the cover (front upper), the cover
(front lower) and the cover (PCB).
4, Remove each cord processing and disconnect
the cords.
5, Remove two power supply box set screws
and take off the power supply box.
6, Remove four case (power supply box upper)
set screws and take off the case (power
supply box upper).
Power supply box
Power supply box set screws
Case set screws
Case (power supply box upper)
Nov./2007 Printed in Japan
Photo-16,17
Photo-1
Photo-2,5
Photo-16
Photo-16
Photo-17
Fuse cover
Photo-16
Current Fuse
Photo-17
- 13 -
7, Take off latches of upper and lower libs and
take off the POWER switch.
POWER switch
SANYO Electric Co.,Ltd
Osaka, Japan
HEC-FX1/RX1
Photo-18
Power cord
Photo-18