Panasonic S-26PU1U6 Operating Instructions Manual page 19

163011_SingleSplit_EN_2.fm Page 19 Thursday, September 15, 2011 9:03 AM
HOW TO SET ADDRESS (
Setting addresses of indoor units for remote controller
Setting Remote Control Addresses
1. If you press and
2. While holding down, every time you press
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release , the address that was displayed is set.
When you do this, if it corresponds to the receiver's address setting, the buzzer sounds.
Address
Display on the
Remote
Controller
CZ-RWSU1U
Position of The position of the
receiver's receiver's address
(inside indoor switch does not
unit) address matter.
switch
CZ-RWSC1U
Position of The position of the
the Receiver's receiver's address
Address Switch switch does not
matter.
Setting Addresses (CZ-RWSK1U / K1 Type)
(Setting the address of the indoor unit)
1. First of all, set the address for the remote controller with Setting Remote Control Address.
2. Press [Emergency Operation]
When you do this, the lamps of the display will blink one after another.
3. Press on the remote controller.
4. The buzzer will sound and the address of the indoor unit will change to the address displayed on the remote controller.
5. If you press [Emergency Operation]
NOTE
• Please do not hold the [Emergency Operation]
after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
)
at the same time, "SET" will blink.
, it cycles from ALL
of the indoor unit for four seconds or more.
of the indoor unit once, the lamps on the indoor unit's display will turn off.
button of the indoor unit down while the indoor unit's display lamps are blinking one
1 2 3... 6 ALL.
For 1, 2 and 3, set the switch on the
right and for 4, 5 and 6, to the left.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.
19