Installing The Starboard Software; Installing The Devices (Using The Installation Wizard) - Hitachi StarBoardLink EZ User Manual

StarBoardLink EZ

2.1 Installing the StarBoard Software

Before Starting to Connect Equipment
Install the StarBoard Software on your PC before starting to connect equipment. The
equipment might not operate correctly if it is connected without the software being
installed.
About PC Earth
Depending on your PC, an incorrect operation might be caused by PC noise via the
USB cable. If this happens, verify that the earth of your PC's power supply cable is
connected.
If the earth is not connected, it might cause an incorrect operation.

2.2 Installing the Devices (Using the Installation Wizard)

- For Windows users, run "Start" → "All
Programs" → "StarBoardLink EZ Setup
Wizard".
For the next steps in the device installation, follow the instructions in the installation wizard.
The StarBoard will be available for use when the wizard procedures are completed.
If you have moved the StarBoardLink EZ to a different installation location, run the
"StarBoardLink EZ Setup Wizard" again.
- For Mac users, run "Go" → "Applications" →
"StarBoard" →"StarBoardLink EZ Setup
Wizard".
2-2
Assembly and Setup
English