Kenwood TK-880 Service Manual page 26

TK-880/H
7. PA/HA Unit (KAP-1 : Option)
7-1. Installing the KAP-1 in the Transceiver
The Horn Alert (max. 2A drive) and Public Address func-
tions are enabled by inserting the KAP-1 W1 (3P; white/
black/red) into CN3 on the TX-RX unit (A/2), inserting W2
(3P; green) into CN5 on the TX-RX unit (A/2), and connecting
the KCT-19 (option) to CN2 and CN3 of the KAP-1.
• Installation procedure
1. Open the upper case of the transceiver.
2. Insert the two cables (
KAP-1 switch unit into the connectors on the transceiver.
3. Secure the switch unit board to the chassis with a screw
( ). The notch (
3 2
front left side.
4. Attach the cushion on the top of the KAP-1 switch unit.
3
W1
W2
CN1
CN2
CN3
1
CN3
CN5
26
INSTALLATION
) with connectors from the
1
) in the board must be placed at the
Cushion
(G13-1710-04)
4
2
1
KCT-19
Fig. 10
8. Fitting the Control Panel Upside Down
The TK-880/880H control panel can be fitted upside
down, so the transceiver can be mounted with its internal
speaker (in the upper half of the case) facing down in your
car.
1. Remove the control panel and the TX-RX unit (B/2) con-
trol section. (Fig. 11)
Fig. 11
2. Fold the flat cable ( ) in the opposite direction (
1
3. Rotate the control section (
4. Insert the flat cable into the control section connector,
CN502 ( ).
5
5. Mount the control section on the transceiver (
2
6
CN502
3
4
Fig. 12
).
2
) 180 degrees ( ).
3 4
).
6
1
5