Replacing Ribbon Cartridge - Pyramid 2650 User Manual

AUTO ALIGNING TIME CLOCK INSTRUCTIONS
Model 2650

REPLACING RIBBON CARTRIDGE

For optimum performance, the ribbon cartridge should be replaced every 6 months.
F
A – Ribbon Cartridge C – Tab
B – Clips
1
Prior to removing old ribbon, press button 4 & hold for approximately 6 seconds
to park ribbon in center position.
Unplug time clock.
2
To remove old ribbon, pull two white clips
3
ribbon cartridge, pull straight up using tab
Remove new ribbon cartridge from packaging & turn the manual ribbon advance
4
knob clockwise to straighten ribbon.
E
5
Holding tab
lower the ribbon in front of the ribbon guide
retaining pins
6
Gently push down cartridge until it snaps into carriage while turning the manual
ribbon advance knob clockwise.
7
Turn manual ribbon advance knob clockwise a few rotations to ensure ribbon is
positioned correctly in front of print head.
8 Replace the cover & lock unit.
Feed a time card through unit to test print quality.
9
If time clock prints incomplete characters, the ribbon is not fully installed over print
head. If time clock prints lines that become increasingly light, the cartridge is not
fully snapped into the holder. Reinstall ribbon cartridge, following steps 1-7 until a
complete & consistent time card prints.
For assistance, please contact customer support at 888.479.7264 ext 1.
12 REPLACING RIBBON CARTRIDGE
Select
1 2 3
D – Ribbon Guide F – Retaining Pins
install ribbon cartridge into print carriage, making certain to
C
are within clips
F
4 5 6
B
C
(see diagram).
B
A
D
E
C
B
E - Manual Advance Knob
towards you & simultaneously lift
located on top of cartridge.
first, then make certain
D
888.479.7264