ADVICE ON CHILD SEATS
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
Remember to fasten the seat belts or
the child seat harnesses keeping the
slack in relation to the child's body to a
minimum , even for short journeys.
For optimum installation of the "forward
facing" child seat, ensure that the back
of the child seat is in contact with the
back of the vehicle's seat and that the
head restraint does not cause any
discomfort.
If the head restraint has to be removed,
ensure that it is stored or attached
securely to prevent it from being
thrown around the vehicle in the event
of sharp braking.
Children under the age of 10 must not
travel in the "forward facing" position
on the front passenger seat, unless
the rear seats are already occupied by
other children, cannot be used or are
absent.
Deactivate the passenger's airbag
when a "rear facing" child seat is
installed on the front seat.
Otherwise, the child would risk being
seriously injured or killed if the airbag
were to infl ate.
As a safety precaution, do not leave:
-
one or more children alone and
unsupervised in a vehicle,
-
a child or an animal in a vehicle
which is exposed to the sun, with
the windows closed,
-
the keys within reach of children
inside the vehicle.
To prevent accidental opening of the
doors, use the "Child Lock".
Take care not to open the rear windows
by more than one third.
To protect young children from the rays
of the sun, fi t side blinds to the rear
windows.
Installing a booster seat
The chest part of the seat belt must
be positioned on the child's shoulder
without touching the neck.
Ensure that the lap part of the seat belt
passes correctly over the child's thighs.
CITROËN recommends the use of a
booster seat which has a back, fi tted
with a seat belt guide at shoulder level.
CHILD LOCK
This prevents opening of the side
doors from the inside.
Child safety
Manual mode
A label indicates the location of the
child lock.
-
Open fully past the point of
resistance.
-
Tilt the lever, located on the rear
section of the door.
Electric mode
With the ignition on, press this
button. The LED comes on.
Warning: this system is
independent of the central
locking control.
Always remove the ignition key when
leaving the vehicle, even for a short time.
It is advisable to check the activation of
the child lock each time the ignition is
switched on.
In the event of a serious impact the
electric child lock is deactivated
automatically.
4
Need help?
Do you have a question about the BERLINGO and is the answer not in the manual?
Questions and answers
The mic for handsfree calls isn't working, is there a quick fix?
What is the height of a Berlingo 2019 from ground to top of roof bars,
The height of a 2019 Citroen Berlingo, measured from the ground to the top of the car, ranges from 1834 mm to 1860 mm depending on the variant.
This answer is automatically generated
Many thanks. The variant is a 2019 Citroen Berlingo 1.5 Blue HDi Flair M MPV EAT Euro 6 (s/s) 5dr
What is the best roof box to put on a Citroen Berlingo 2019 M MPV so that it will clear a 1.9 m or 2.1 m parking barrier? I already have lateral roof bars, but will have to add a pair of lateral bars.
The document mentions a specially designed roof box for the Citroën Berlingo Multispace, adding up to 430 liters of extra storage. However, it does not provide specific dimensions for the roof box or the vehicle’s height with it installed. To ensure the total height remains under 1.9 m or 2.1 m, you should check the Berlingo MPV's standard height and the roof box's dimensions. If necessary, consult a Citroën dealer for compatibility with parking barriers.
This answer is automatically generated
@Mr. Anderson Many thanks. I will consult Citroen.
What is the best roof box to put on a Citroen Berlingo 2019 M MPV so that it will clear a 1.9 m or 2.1 m parking barrier? I already have lateral roof bars, but will have to add a pair of transverse bars.
How to fit front side light bulbs
To fit the front side light bulbs in a Citroën Berlingo:
1. At the back of the lamp, remove the air filter pipe to access the bulb cover.
2. Unscrew and remove the black 3-inch round plastic bulb cover.
3. Reach inside and pull out the bulb holder.
4. The bulb is a push-fit type, so pull it out carefully.
5. Insert the new bulb securely into the holder.
6. Reassemble by placing the holder back, screwing the cover on, and reinstalling the air filter pipe.
This answer is automatically generated
How to fitt a new rear passenger seat belt
I can't open the sliding doors