1) WORK AREA SAFETY Definitions: Safety Guidelines a) Keep work area clean and well lit. Cluttered or dark areas invite accidents. b) Do not operate power tools in explosive atmospheres, such as in the The definitions below describe the level of severity for each signal presence of flammable liquids, gases or dust.
c) Prevent unintentional starting. Ensure the switch is in the off position g) Use the power tool, accessories and tool bits etc., in accordance with before plugging in. Carrying power tools with your finger on the switch or these instructions and in the manner intended for the particular type of plugging in power tools that have the switch on invites accidents.
Further Safety Instructions for All Operations accessory. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory and run the power KICKBACK AND RELATED WARNINGS tool at maximum no-load speed for one minute. Damaged accessories will Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, normally break apart during this test time.
Electrical Safety Additional Specific Safety Instructions for Polishers The electric motor has been designed for one voltage only. Always check that the • Clean out your tool often, especially after heavy use. Dust and grit containing metal particles often accumulate on interior surfaces and could create an electric power supply corresponds to the voltage on the rating plate.
INTENDED USE D. Brush inspection cap J. Soft rubber gear case cover The DWP849X-XE heavy-duty polisher is designed for polishing painted or unfinished E. Spindle lock button K. Wool ingestion shield metal, fiberglass, and composite surfaces in professional applications. Common F.
Page 8
It’s this feature, A bale handle is also provided with the DWP849X-XE and can be used in place of the coupled with the variable speed trigger switch, that make this tool such a value.
15.2, 17.8 or 22.9 cm (6", 7" or 9") Your tool may come with a set of wool ingestion shields. The wool ingestion shields may be used with the DWP849X-XE. are available at extra cost from your local dealer or authorized service center.
Page 10
NOTE: The DWP849-XE may use either type of polishing pad assembly described TO REMOVE PADS below. Turn them by hand in the opposite direction from normal rotation to allow lock button TO ATTACH POLISHING PAD WITH RUBBER BACKING PAD (FIG. 3A) to engage spindle, then unscrew pads in normal direction for right-hand thread.
Motor Brushes you have a firm grip on the handles and operate the tool freely without forced effort or unnecessary pressure. The side handle can be easily changed to either Be sure tool is unplugged before inspecting brushes. Carbon brushes should be side of the tool for left-handed or right-handed operation.