Dsi (Disabled System Indicator); Dual Zone System Setting; Bass Management System); B.m.s. Frequency Offset - Kenwood DPX-MP4090 Instruction Manual

In Standby mode

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the ACC
is set to OFF, warning potential thieves.
Display Setting
"S.I ON" LED flashes.
"S.I OFF" LED OFF.
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel
sound in the Dual Zone System.
Display Setting
"ZONE2 R" Sub source (Auxiliary input source) is to be rear
channel.
"ZONE2 F" Sub source (Auxiliary input source) is to be front
channel.
Other than Standby mode
B.M.S. (Bass Management System)
Adjust the bass boost level of the external
amplifier using the main unit.
Display Setting
"BMS FLT" Bass boost level is flat.
"BMS +6" Bass boost level is low (+6dB).
"BMS +12" Bass boost level is mid (+12dB).
"BMS +18" Bass boost level is high (+18dB).
• Refer to the catalog or instruction manual for power
amplifiers that can be controlled from this unit.
• For amplifiers, there are the models you can set from
Flat to +18 dB, and the models you can set from Flat
to +12 dB.
When an amplifier that can only be set to +12 is
connected to the unit, "BMS +18" will not work
correctly even if it is selected.
Other than Standby mode

B.M.S. Frequency Offset

Setting the central frequency, boosted by B.M.S.
Display Setting
"BMSF NML" Boost with the normal central frequency.
"BMSF Low" Drop the normal central frequency 20%.
In FM reception
CRSC (Clean Reception System
Circuit)
Temporarily have reception alternate from
stereo to mono to reduce multi-path noise when
listening to the FM station.
Display
"CRSC On"
"CRSC Off"
• Strong electrical fields (such as from power lines) may
cause unstable sound quality when CRSC is turned
ON. In such a situation, turn it OFF.
Setting
The CRSC is ON.
The CRSC is OFF.
25
|
English