Samsung LT-P326W Owner's Instructions Manual page 82

T
R O U B L E S H O O T I N G
Problem Possible Solution
See if there are Anynet devices connected.
The Anynet System supports only Anynet devices.
Check to see if the Anynet devices connected are plugged in
properly.
Check to see if the Anynet devices are connected properly
according to the Anynet connection diagram. (Make sure that
the Output port of the TV is connected to the Input port of the
Anynet device and the Output port of the Anynet device is
connected to the Input port of the other Anynet device.)
Connect the video cable of the device to the TV according to the
connection diagram.
Then go to [Settings] in the Anynet menu and select
[Basic Connection Setting] or [Advanced Connection Setting].
Check to see if the video cable is damaged. Then go to [Settings]
in the Anynet menu and select [Basic Connection Setting] or
[Advanced Connection Setting].
If the video cables are connected properly, set the input source to
the Anynet device (Combo) using the Input button on the remote
control and see if the display works properly. If it does not work
properly, see Troubleshooting for such device (Combo).
Check to see if the device is plugged in properly.
Then go to [Settings] in the Anynet menu and select
[Basic Connection Setting] or [Advanced Connection Setting].
Check to see if the cables are connected properly according to
the instructions.
Then go to [Settings] in the Anynet menu and select
[Basic Connection Setting] or [Advanced Connection Setting].
If the device is connected properly, turn the TV off and go to
[Settings] in the Anynet menu and select [Basic Connection
Setting] or [Advanced Connection Setting].
Check to see if two or more of the same type of device are
connected and if so, remove all such devices but one.
The Anynet System does not function when more than one of the
same type of device is connected.
Check the number of the Anynet devices connected and connect
the devices properly according to the connection diagram.
Then go to [Settings] in the Anynet menu and select
[Basic Connection Setting] or [Advanced Connection Setting].
(The Anynet System supports up to one device from the Receiver
product group and two devices from the DVD product group.)
79
English-