Advertisement

child trailer
Burley Bee
and Honey Bee
Owner's Instruction and Safety Manual
Designed For One
Or Two Children
H
oney Bee
Burley Bee
model shown

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Bee and is the answer not in the manual?

Questions and answers

Summary of Contents for Burley Bee

  • Page 1 Burley Bee and Honey Bee ™ ™ Owner’s Instruction and Safety Manual Designed For One Or Two Children ™ oney Bee Burley Bee model shown ™...
  • Page 2: Table Of Contents

    Burley Bee and Honey Bee ™ ™ Owner’s Instruction and Safety Manual child trailer Contents Introduction Safety Guidelines Tool List Opening Your Trailer Attaching the Seat Mounting Reflectors Installing Wheel Guards Attaching Wheels Using Parking Brake (Honey Bee) Installing and Operating Tow Bar Using Stroller (Honey Bee) 8 Attaching Handle (Honey Bee) 8 Installing Safety Flag 8 Installing Cover 9 Using Seat Harness 9 Hitching Trailer to Your Bicycle...
  • Page 3: Introduction

    2. Because of the trailer’s additional weight, a bicycle pulling a trailer is heavier and less responsive. Avoid sudden swerving, IT IS VERY IMPORTANT FOR YOU TO FAMILIARIZE YOURSELF WITH YOUR BURLEY BY rocks and curbs. Experiment with the loaded trailer in an READINg THIS ENTIRE MANUAL BEFORE USE.
  • Page 4: Tool List

    5 mph/8km/h or less when turning or on uneven roads. Bee: Phillips screwdriver ™ 12. Use your parking brake (Honey Bee) or bring the trailer to a Honey Bee: ™ Phillips screwdriver complete stop before removing your children or cargo.
  • Page 5: Attaching The Seat

    Attaching the Seat IMPORTANT: Attach hooks on seat sides to D-rings by windows. Always keep MAkE SURE REFLECTORS FACE OUTWARD. INCORRECTLY INSTALLED REFLECTORS CAN these attached while trailering. REDUCE VISIBILITY AND CASE AN ACCIDENT OR SERIOUS INjURY. Mounting Reflectors Installing Wheel Guards 1.
  • Page 6: Attaching Wheels

    2. Line up BACK tow bar hole with rear receptacle hole. 3. Insert retaining pin through rear holes, and lock hoop securely. Figure 7 4. Honey Bee: Engage parking brake and tighten knob to secure stroller wheel in “Bike” position. WARNING MAKE SURE WHEELS ARE HELD SECURELY, WITH WHEEL SHAFT FULLY INSERTED INTO HOLLOW AXLE.
  • Page 7 Stroller (Honey Bee): To Adjust Honey Bee Stroller Wheel Tracking: 1. Engage parking brake. 1. Tighten knob to secure stroller wheel in “Stroll” position. 2. Place stroller wheel in “Stroll” position and secure by 2. Loosen bolt using 5mm hex wrench.
  • Page 8: Attaching Handle (Honey Bee)

    Attaching Handle (Honey Bee) Installing Safety Flag 1. Slide handle into lower handle bar receivers and tighten knobs. To change height position, flip handle over. Figure 10 Join two flag sections together. On outer left side of trailer, insert flag pole into flag pocket.
  • Page 9: Using Seat Harness

    Using Seat Harness Hitching Trailer to Your Bicycle 1. Remove quick release lever assembly from bike. WARNING 2. Match hole on flat side of hitch upper arm to left (non-chain ring side) rear dropout hole. ALWAYS SECURE CHILDREN WITH HARNESS AND LAP BELT DURINg USE. ONLY USE THIS SEAT IF YOUR CHILD IS CAPABLE OF SITTINg UPRIgHT ALONE.
  • Page 10: Safety Checklists

    Seat fastened securely to trailer (to help avoid mildew) and store out of direct sunlight in a dry, well-ventilated area, or use a Burley Trailer Storage Cover to Children properly secured with harnesses and lap belt protect your trailer. Cover window may crack if trailer is stored Monthly Checklist below 32°F (0°C).
  • Page 11: Warranty

    2008 Honey Bee and Bee Replacement Parts and Diagram Honey Bee Diagram # Description Warranty Part # Part # 960000 960000 Standard Hitch 5 years 960009 960009 Safety Flag 1 year 950003 Handle Bar Clamp Kit 3 years 250033 Handle Assembly w/Tether 5 years 950004 950004 Shoulder Safety Strap (Set of 2) 1 year 250102 250107 Seat (NOT SHOWN)
  • Page 12 Burley Trailer Limited Warranty Burley trailers are warranted from date of purchase against defects in materials and workmanship under normal use and service. Burley will repair or replace parts it determines to be defective as follows: fabric parts for one year, plastic parts for three years and durable frame parts for five years. The Burley trailer owner must present the trailer for repair at place of purchase, with an original sales receipt or similar proof of purchase. This warranty applies only to the original owner and is nontransferable. Burley can not be responsible for failure due to improper assembly, modification of parts or instructions, neglect, abuse, accident, and/or normal wear. The warranty does not cover any trailer used for rental, competition, or commercial use. Burley neither assumes nor authorizes any person to assume any other liability in connection with this Burley product, and there are no oral agreements or warranties collateral to or affecting this agreement. This warranty gives you specific rights. You may also have other rights which vary by state or country. Copyright © 2007 by Burley Design LLC “Burley” is a registered trademark of Burley Design LLC “Bee,” and “Honey Bee” are trademarks of Burley Design LLC 170037 manual bee, honey bee 08 r1 Rev 11/07...

This manual is also suitable for:

Honey bee

Table of Contents