Yamaha Apex RX10RZ Owner's Manual page 75

Shifted to left
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
5. Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing bolts should be turned an
equal amount.
Drive track More than
deflection specified
Left adjusting
bolt
Right adjust-
ing bolt
6. Tighten the locknuts to their specified
torque.
Locknut tightening torque:
59 Nm (5.9 m·kgf, 43 ft·lbf)
7. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 6 until the prop-
er adjustment is achieved.
8. Lower the snowmobile to the ground.
9. Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Adjusting the drive track (RX10MT)
1. Loosen the rear axle nut.
Periodic maintenance and adjustment
[ECS00970]
Less than
specified
Turn in Turn out
Turn in Turn out
1. Rear axle nut
2. Lift the rear of the snowmobile onto a suit-
able stand to raise the drive track off the
ground.
3. Start the engine and rotate the drive track
one or two turns. Stop the engine.
4. Check the drive track alignment with the
slide runners. If the alignment is incorrect,
align the drive track by turning the left and
right adjusting nuts.
1. Slide runner
Drive track Shifted to
alignment
Left adjusting
Turn out
nut
Right adjust-
ing nut
1
Shifted to left
right
Turn in
Turn in Turn out
69