Sony PMW-10MD Operating Instructions Manual page 64

you wish to set then press the knob to
proceed.
The setting area appears to the right of the
menu item selection area, and the cursor
moves to the top of its subitems.
Setting area
• The subitems and their current values are
displayed.
• To return to the previous layer, select
press the CANCEL button.
When you select an item that has no subitems
and to be only On /Off or switched, the
choices are displayed to the right of the item.
In this case, proceed to step
Example
Choices
4
For the item that has subitems, turn the
SEL/SET knob to set the cursor to the
subitem you wish to set then press the
knob to proceed.
The available values of the selected subitems
are displayed, and the cursor moves to the
current value.
• The available value area can show seven
lines at maximum. When all the selectable
values cannot be displayed at one time, you
can scroll the display up or down by
moving the cursor.
A triangle appears at the upper or lower
64
Basic Menu Operations
or
5
.
Available value area
right corner of the available value area to
indicate that scrolling is enabled.
• For items having a wide range of available
values (example: –99 to +99), the available
value area is not displayed. The current
setting is highlighted instead, indicating
that the setting is ready for change.
5
Select the desired value by turning the
SEL/SET knob to make the setting.
The setting is changed, and the new setting is
displayed.
When you select "Execute" for an execution
item, the corresponding function is executed.
For an item that requires your confirmation
When you select an item that you must confirm
3
before execution in step
temporarily disappears, and a confirmation
message is displayed. Following the instructions
of message, specify whether to execute or cancel.
Entering a character string
When you select an item for which a character
string, such as a time value or filename, is to be
specified, the input area for the character string is
highlighted, and "SET" appears at the right end.
1
Select characters by turning the SEL/
SET knob then press the knob to
proceed.
The cursor moves to the next column.
2
Perform setting in the same manner up
to the last column/digit.
The cursor moves to "SET."
3
Press the SEL/SET knob.
The setting is completed.
Terminating the menu operation
Press the MENU button.
The normal camera output picture is resumed.
, the menu display