Continuous Bar Code Read; Decode Session Timeout - Motorola DS3508 Product Reference Manual

Continuous Bar Code Read

Enable this to report every bar code while the trigger is pressed.
NOTE Motorola strongly recommends enabling Picklist Mode on page 4-23 with this feature. Disabling Picklist
Mode can cause accidental decodes when more than one bar code is in the imaging engine's field of view.
*
Disable Continuous Bar Code Read
(0h)

Decode Session Timeout

This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
Numeric Bar Codes that correspond to the desired on time. Enter a leading zero for single digit numbers. For
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan Cancel on
Decode Session Timeout
User Preferences & Miscellaneous Digital Scanner Options 4 - 27
Enable Continuous Bar Code Read
page
(1h)
D-2.
Appendix D,