Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Generic Trigger X
Summary of Contents for Generic Trigger X
- Page 2 Attention: The first driving 1000km is very important for the whole driving life. With a careful driving you can improve the lifetime and power of the engine and the whole vehicle. Preface: Thanks for the choosing of Trigger motorcycle. We have absorbed the advanced technology abroad and domestic, to provide the happy and safety driving.
- Page 3 Helmet and exposure suit: To keep the safety, the driver must dress the helmet and should have goggle, boot, glove and exposure suit, also the passenger also must dress the helmet. During the driving period, the exhaust system becomes heat, even when you stop the engine a moment, it still is heat, don’t touch the exhaust system when it is heat.
- Page 4 Location of the Parts: (1) Rear view mirror (2) Left handle switch (3) Speedometer (4) Steering lock (5) Right handle switch (6) Fuel tank cap (7) Clutch controller grip (8) Air cleaner (9) Seat lock (10) Front detent (11) Fuel tank lock (12) Gear shift footplate (13) Side stand (14) Water tank cap...
- Page 5 Main Parts: Speedometer and indicator SPEEDOMETER Indicates speed in km/h. Odometer indicator Indicates total distance Turning indicator When lift or right turning signal is on Far sight indicator Lights up when blue far sight light is in the on position. Near sight indicator Lights up when green near sight light is in the on position.
- Page 6 Main switch power switch “ ”（off）：all the electrict parts are off “ ”（on ）：engine can be started. Stearing Lock Turn handle bar to the left, insert key, push down and anticlockwise turn, draw the key out when locked. WARNING： CAUTION： DON’T IMPEL WHEN MOTORCYCLE IS MAKE SURE TURING LOCK IS LOCKED LOCKED,OTHERWISE...
- Page 7 LEFT HANDLE Dimmer Switch Turn switch to“ ”position，the head light work，Meanwhile, high beam indicator on instrument panel will light. Switch to“ ” head light goes downward and works. When switch is on“ ”，the head light works in middle and this indicates the vehicles that are passed.
- Page 8 FUEL TANK SWITCH ●OFF When the fuel switch is on the position "●" no fuel runs to the carburettor. Please turn off the switch when you don’t ride the motorcycle. When the switch on the position" ", the fuel will be poured into carburetor from the main fuel tank.
- Page 9 FUEL TANK CAP When filling fuel, please turn the cap to right side. After filling, please turn left for tighten. NOTICE Please use fuel with 95 Oct at least or the higher standard kinds of fuel. WARNING Fuel tank can not be excessively filled. It is very dangerous to spatter fuel to the hot engine. WARNING When fill the fuel, the engine should be ended and turn the ignition key to the “off"...
- Page 10 SIDE STAND Side support is at the left side of vehicle. When vehicle stops, please kick the side support down. When you make the vehicle stand-up, side support will be back automatically. NOTICE Do not stop the vehicle on a downward ground，this may turn over the vehicle.
- Page 11 BRAKE HANDLE AND BRAKE PEDAL Turn down the brake handle, this will brake the front wheel and the brake light works. When stepping on the brake pedal the rear wheel brakes and the brake light works. SEAT LOCK Insert the key to the lock and turn to open it. Then lift the rear part of seat up.
- Page 12 Checking before driving Before driving your motorcycle, you must check it as followings。Don’t neglect the importance of checking and complete it before driving. content Inspection focus 1）steady Handle Bar 2）turning agile 3）have not become less crowded 1）handle and footplate have the right gap Brake System 2）the response of brake is sensitive 3）have adequate brake oil...
- Page 13 Key point of driving Starting the engine Check whether or not the fuel switch is on the position of “ ”, put the key into the switch and turn the position of “ ”, let the transmission gear on the zero position and the neutral indicator is on. When engine is cold set the choke on the close position, use the kick-starter or the electric starter to start the engine.
- Page 14 Driving on the slope When driving on the slope, the motorcycle decreases the speed and seems inadequate power, in that case, please change the lower gear so that keeping the power. When driving downhill, please change the lower gear in order to break easily. Please don’t let the engine’s rotate speed too high. Using the brake system and stopping the motorcycle Shut down the accelerograph ，turn the steering handle against the driver，use the brake systems equably, change the lower gear to reduce the speed.
- Page 15 CHECKING AND MAINTAINING: The following table shows the regular maintenance time accord the kilometers traveled. When the times drawing near, please check lubricates and maintain according the instruction. Redirector system, supporting and wheel system is the key parts and request technical staff maintain them. We suggest you consign sales department or qualified technical staff to check and maintain it Maintenance schedule I：check、clean、adjust、lubricate or replacing;...
- Page 16 As the right picture shows with a little pull, You can open the sump cap. CAUTION： Only use the oil of you authorized Generic Dealer. Only use the right 2-Stroke engine oil. CASTROL Power 1 Racing Gear box oil lever and replace the gear oil gear oil level Before start the engine, please check the gear oil level.
- Page 17 Water tank The cycle was adopted the form of water-cooling, it locates in the front of cycle, right. Please look at photo. Before riding motorcycle, please balance the cycle and check that how many water is there? WARNING Don’t open the cover of water tank when the engine is hot. Spark Plug CAUTION: please don’t screw the spark plug too strictly or intervene the worm, do this, it’ll mangle the worm of the cylinder cover.
- Page 18 Battery The cycle’s battery don’t need maintenance, it is been installed in air cleaner box that locate in seats. The battery doesn’t need to check the lever of liquid and add electrolyte. If you find the battery lacks energy and gives birth to jump- starting trouble, weak light and feebleness horn, please keep touch with dealer that authorized by QIANJIANG or maintenance sector.
- Page 19 The Regulation of Accelerograph Tight wire When you want to check valve’s artificial switch in the left, right of whole turning orientation, from whole opening orientation to whole closing orientation, whether they are agility or not. To measure free extent of valve’s artificial switch at side of valve’s artificial switch. The standard of free extents: 10°～15°...
- Page 20 Driven chain The life-span of driving chain depend on the proper lubricate and adjustment. Improper maintenance may result in earlier abrasion of driving chain and chain wheel. Driven chain’s regulation When you drive 1000 kilometers everytime,take the following step to adjust the laxity of the driving chain in order to maintain the vertical of driving chain between 10mm and 20mm.According to your driving condition, the driving chain needs adjust frequently.
- Page 21 Drive chain lubricant is prior to other types of machinery oil or lubricant. It’s available in most motorcycle distributors. Dipping each chain coupler to make lubricant saturate chain shutter, pin, bush and roller. Brake Disc brake at the front and rear wheel. It’s very important to operate brake correctly. Must check brake system periodically by qualified distributors.
- Page 22 BRAKE SYSTEM Warning: We suggest you ask distributor to repair the brake system or parcel. They’re more professional and can assure security Caution: Disc brake system is applying high pressure brake. For the sake of security, replace pipe and brake liquid according to user manual strictly. Please check below items everyday: Check if there’s liquid leaking exist in both front or rear wheel Check if there’s leaking or crack in oil pipe...
- Page 23 Taking care of Air filter Air filter should be maintained in time, especially in the dusty or sandy area Open the seat and disassemble the tail bar. First disassemble the left rim bar on the lower place of motorcycle. Turn the screws off (1), disassemble the cover of air filter off (2), and then take the filter out.
- Page 24 The replacement of tail lamp Caution: The cathode wire should be reassembled on the frame Use the screwdriver to driver the screw off, then open the tail lamp cover, replaces a new same standard bulb on Attention: When replacing the bulb, must need the same standard as the original, the higher power bulb will increase the possibility of battery decrease.
- Page 25 Tire The proper tire pressure can provide stability, comfortable and durability of tire. Inspect the tire pressure, and adjust in time Attention: Before riding, check the tire pressure. Front Rear Rider only 1,75 Bar (172Kpa) 2,0 Bar (196Kpa) Rider with passenger 2,0 Bar (196Kpa) 2,25 Bar (221Kpa) Alarm:...
- Page 26 Guide of storing Storing: If need long time store, we need some maintenance action to maintain the quality of motorbike Change the oil. lubricate the driving chain empty the fuel tank and gas in the carburettor Attention: If the storing time is over one month, in order to maintain the performance after storing, empty the gas in the carburetor is very important.
- Page 27 SPECIFICATION AND TECHNICAL PARAMETER Measure and weight Length: 2035mm Width: 890mm Height: 1230mm Wheelbase: 1390mm Weight: 111Kg Engine Type: single cylinder, two stroke, water cool Engine number: QJ1E40MB-2 Cylinder diameter×a stroke: 40.25mm×39mm Exhaust: 49.6CM3 Nominal exhaust: 50CM3 Maximum power: 1.39kW/5500min-1 Maximum N/M: 2.6Nm/3000min-1 Ignition mode:...
- Page 28 Electric system Battery: 12V3AH Generator: flywheel everlasting magnetic Head lamp: 12V35/35W Tail lamp: 12V5/21W Turning signal lignt: 12V/10W Front parking light: 12V/5W Rear license plate light: 12V/5W Specific of horn: 12V1.5A Volume Design maximum speed: 45km/h Climb ability: 15° Load ability: rider and one passenger Fuel tank: Engine oil:...
Need help?
Do you have a question about the Trigger X and is the answer not in the manual?
Questions and answers