The Nitro Stampede is not intended for use by children without the supervision • Do not allow the antenna wire to of a responsible adult. Traxxas shall not be liable for any loss or damages, extend outside the body without...
Steering Trim The TQ 2.4GHz Radio System Your Nitro Stampede Model 41094 is equipped with the Traxxas TQ 2.4GHz transmitter. The transmitter has two channels: channel one operates the steering, and channel two operates the throttle. The receiver inside the model has three output channels. Your model is Throttle equipped with two servos and a receiver.
Installing Transmitter Batteries • Always have the transmitter and receiver turned on before you start the engine. Never turn the radio system off while the Your TQ 2.4GHz transmitter uses 4 AA batteries.The battery engine is running.The on/off switch in the model only turns the compartment is located in the base of the transmitter.
Page 5
Warning: Changing the direction of the throttle servo will also No matter how fast or far you drive your model, always leave adequate space between you, the model, and others. Never change its neutral position. Be certain to confirm the throttle drive directly toward yourself or others.
For the best filtration, use the compartment door to open. (A) type of oil made for foam air filters. Traxxas air filter 2. Plug a fully charged 7.2-volt battery pack oil is recommended (part #5263). Lightweight motor into the connector inside.
and low throttle. This adjustment will smooth the idle and improve During Break-in... acceleration to mid-speed. Make this adjustment with the throttle • Special break-in fuels are not required. closed, after setting the idle. Gently turn this screw clockwise until •...
Page 8
Richen the fuel mixture to the infrared temperature probe or on-board optimum setting by richening the high-speed needle at least 1/8 temperature gauge (such as the Traxxas turn counterclockwise and retest. This setting will extend engine Part #4091 on-board temperature gauge, part #4091).
Page 9
the engine performance does not change, then you have exceeded suspension. If it is picking up the inside front wheel in hard turns, the maximum safe lean setting. then stiffen the rear suspension. Proper set-up will add stability and help prevent roll-overs. If tuning for maximum performance results in engine temperature Gear Ratios exceeding 300°F, try to increase airflow to the engine by cutting out...
Centering your Servos • Clean the outside of the engine of accumulated dirt, oil, and grime. Accumulated grime will decrease the engine’s ability to cool itself. Whenever your radio system has been removed for service or cleaning, • Tighten the wheel nuts (especially on the left side). the servos must be re-centered prior to installing the radio system in the model.
Page 11
This is most likely to happen on new engines during break- Traxxas makes three glow plugs. The standard hot plug (part #3230) in, but can also happen at other times. If the engine is stuck at TDC, is the stock replacement plug for Pro.15 engines.
Page 16
Radio Frequency (RF) Exposure Information The radiated output power of the Traxxas LP Device is below the Industry Canada (IC) radio frequency exposure limits.The antenna for this transmitter must not be co-located with any other transmitters except in accordance with FCC and Industry Canada multi-transmitter procedures. Co-location means having a separation distance of less than 20 cm between transmitting antennas.
Need help?
Do you have a question about the Nitro Stampede 41094 and is the answer not in the manual?
Questions and answers