Expansion Board Options - HP ProLiant DL320e Gen8 User Manual

Install the DIMM.
7.
Install the air baffle (on page 20).
8.
Install the access panel (on page 19).
9.
Do one of the following:
10.
Slide the server into the rack.
o
Install the server into the rack
o
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Power up the server (on page 16).
13.

Expansion board options

The server has both full-height and low-profile expansion slots for controller option installation
board slot definitions" on page 10).
CAUTION:
all expansion slots have either an expansion slot cover or an expansion board installed.
To install the component:
Power down the server (on page 16).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 16).
o
Remove the server from the rack (on page 17).
o
Remove the access panel (on page 18).
4.
Remove the PCI riser cage (on page 20).
5.
("Installing the server into the
To prevent improper cooling and thermal damage, do not operate the server unless
rack" on page 27).
Hardware options installation 47
("PCIe riser