Radio Reception - Sony XAV-742 Operating Instructions Manual

The Auto OFF function does not operate.
 The Auto OFF function activates when no source
is selected.
 Exit the source.
Menu items cannot be selected.
 Unavailable menu items are displayed in gray.
USB Music, USB Video, AUX, BT Audio and
Pandora (Australia and New Zealand models
only) cannot be selected as the source.
 Remove the check mark from the source item you
cannot select (page 28).
(XAV-742/712BT only)
The monitor angle cannot be adjusted.
 The monitor was opened while the unit was
being reset.
 Be sure to close the front panel before you
reset the unit.
The notification panel does not appear.
 The notification panel is not available when the
unit is;
 at the initial settings.
 displaying the source in a popup.
 under the voice command function (XAV-
712BT/612BT/602BT only).
 playing back USB Video.
The playback controls does not appear in the
notification panel.
 The playback controls are not available when the
unit is playing back content from the following
sources;
 AUX
 USB Video
 HDMI in/MHL in (XAV-712BT/612BT only)
 application on a smartphone via the App
Remote function

Radio reception

The stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Connect the REM OUT lead (blue/white striped)
or accessory power supply lead (red) to the
power supply lead of a car's antenna (aerial)
booster (only when your car has built-in radio
antenna (aerial) in the rear/side glass).
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [PTY not found.].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Picture
There is no picture/picture noise occurs.
 A connection has not been made correctly.
 Check the connection between this unit and
other equipment, and set the input selector of
the equipment to the source corresponding to
this unit.
 The disc is defective or dirty.
 Installation is not correct.
 Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The parking cord (light green) is not connected to
the parking brake switch cord, or the parking
brake is not applied.
 Activate the video output of the iPod.
The picture does not fit in the screen.
 The aspect ratio is fixed on the DVD.
There is no picture/picture noise occurs in the
rear monitor.
 A source/mode which is not connected is
selected. If there is no input, no picture appears
in the rear monitor.
 The color system setting is incorrect.
 Set the color system to [PAL] or [NTSC]
according to the connected monitor (page 24).
 The picture of the rear view camera is displayed
on this unit.
 No picture appears in the rear monitor if the
picture of the rear view camera is displayed on
this unit.
Sound
There is no sound/sound skips/sound cracks.
 A connection has not been made correctly.
 Check the connection between this unit and the
connected equipment, and set the input selector
of the equipment to the source corresponding to
this unit.
 The disc is defective or dirty.
 Installation is not correct.
 Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The MP3 file sampling rate is not 32, 44.1, or 48
kHz.
 The WMA file sampling rate is not 32, 44.1, or 48
kHz.
 The AAC file sampling rate is not 44.1 or 48 kHz.
 The MP3 file bit rate is not 48 to 192 kbps.
 The WMA file bit rate is not 64 to 192 kbps.
 The AAC file bit rate is not 40 to 320 kbps.
39
GB