Resetting To The Factory Default Settings - Hitron HDG-3x0 series Instruction Manual

3.8 Resetting to the factory default settings

To reset the Network Camera to the original factory settings, go to the Setup>System> Maintenance
web page (described in "3.5.5 System > Maintenance") or use the Control Button on the network
camera, as described below:
• Using the Reset Button
Follow the instructions below to reset the Network Camera to the factory default settings using
the Reset Button.
1. Switch off the Network Camera by disconnecting the power adapter.
2. Open the lens cover.
3. Press and hold the Control Button (SW1) on the board with your finger while reconnecting
the power.
4. Keep the Control button (SW1) pressed during about 2 seconds.
5. Release the Control Button (SW1).
6. The network
reset.
7. Close the lens cover.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
resets to factory defaults and restarts after completing the factory
camera
66