Starting The Engine Manually - Yanmar 1GM10 Operation Manual

5. Turn the key switch to the ON position
(Figure 2, (2)). Ensure that the
instrument panel indicators light and
the alarm sounds. This indicates that
the indicators and the alarm are
working correctly.
Note: The water temperature
alarm indicator and water in Sail-
Drive indicator should not come on
during start-up.
( 1 )
OFF ON
Figure 2
1 – OFF position
2 – ON position
6. Push the start button. Release the start
button when the engine has started.
NOTICE: NEVER hold the start
button for longer than 15 seconds
or the starter motor will overheat.
7. The alarm should stop and the indicator
lamps should go out. NOTICE: If any
indicator fails to illuminate when the
key switch is in the ON position, see
your authorized Yanmar Marine
dealer or distributor for service
before operating the engine.
GM Series Operation Manual
( 2 )
0005847
© 2007 Yanmar Marine International
ENGINE OPERATION

Starting the Engine Manually

1. Open the seacock (if equipped).
2. Open the fuel cock.
3. Put the remote control shift lever in the
NEUTRAL position (Figure 3, (1)).
Note: Safety equipment should
make it impossible to start the
engine in any position other than
NEUTRAL.
Figure 3
1 – Starting Shaft
2 – Starting Handle
4. Turn the master battery switch (if
equipped) to ON.
(1)
(2)
0005888
33