Hitachi BD-W3300 Operating Instructions And Owner's Manual page 29

 Add the bleach after adding 
the detergent.
Use the left inlet when using powder
bleach, and the right back inlet
when using liquid bleach
Add the softener into the
right front inlet.
Close the detergent
dispenser.
Bleach
Do not use chlorine-based bleach in programs other than
[TUB CLEAN].
Doing so may result in malfunction of the machine.
 For details on the amount of bleach and how to use it,
refer to the instructions of the oxidizing bleach.
 Do not pour the bleach directly on the laundry.
Doing so may result in discoloration or damage to the
laundry.
Softener
 Do not add detergent into the softener inlet.
Doing so may result in malfunction.
 Do not add the softener and allow it to sit for long
periods (12 hours or more).
Doing so will result in caking.
 The softener may cake in the softener inlet. In such
cases, remove the dispenser and clean it.
 Do not add excessive amounts of softener
(max. 60 mL).
The softener may drain and come in direct contact
with laundry, resulting in discoloration and darkening.
 Using detergents or softeners that are excessively
fragrant or thick or made from natural fats and oils
may result in excessive fragrance after wash. In such
cases, reduce the amount of detergent, or run the
[TUB CLEAN] program.
 If liquid detergent or softener comes into contact with
the top caps in the dispenser, it may cake and remain
there. Avoid the caps when pouring.
 Open and close the detergent dispenser gently.
If the dispenser is opened too quickly, the water,
detergent, bleach, or softener inside the dispenser
may spill out. In addition, if liquid detergent spills into
the softener inlet, the siphon effect may not occur and
the softener may remain in the dispenser.
 Remove the detergent dispenser and clean the
dispenser connection port regularly (i.e., once per
week).
Accumulation of liquid detergent, softener, or bleach
may cause malfunction of the machine and result in
injuries. (P. 75)
 If any liquid detergent, bleach, or softener remains on
the metal parts of the back side of the door or any
plastic parts on the exterior of the machine, wipe it off
immediately with a soft, damp cloth.
Failure to do so may cause rust and deterioration of
the machine parts and result in injuries.
(P. 52)
29