Kyocera ECOSYS P2135dn Operation Manual page 169

Password
_
>>Auto Panel Reset
? On
Using the Operation Panel
3
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use  and  to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK]. Proceed to the next step Password (Administrator
Password input).
Password (Administrator Password input)
To set up the Timer settings, you must enter an administrator ID and
administrator password. For information on how to set the administrator
password, refer to Administrator (Administrator settings) on page 7-
81.
1
Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows Password
(Administrator password input) and a blinking cursor (_).
2
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use  and  to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
Note If you enter the incorrect administrator ID or password,
the message Wrong ID or Wrong Password appears and
the input screen then reappears. Re-enter the ID or password
correctly.
3
Press [OK]. The Timer settings screen appears.
Auto Panel Reset (Auto panel reset settings)
The Auto Panel Reset function automatically restores the default
settings if the panel is not used for a set time. The default setting is On.
For setting the time until the panel is reset, refer to the next section
Panel Reset Timer (Setting the panel reset timer).
1
After entering the administrator ID and password, press  or 
repeatedly until >>Auto Panel Reset appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using  or .
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Panel Reset Timer (Setting the panel reset timer)
When Auto Panel Reset is set to On, this sets the time until the panel is
automatically reset after the user stops using the panel. The default time
is 90 seconds.
1
After entering the administrator ID and password, press  or 
repeatedly until >>Panel Reset Timer appears.
7-63