Traxxas E-Maxx Brushless Edition 3908L Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. E-Maxx 3908L
  6. Owner's manual

Traxxas E-Maxx Brushless Edition 3908L Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

MODEL 3908L
MODEL 3908
owner
s manual
'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-Maxx Brushless Edition 3908L and is the answer not in the manual?

Questions and answers

Related Manuals for Traxxas E-Maxx Brushless Edition 3908L

Summary of Contents for Traxxas E-Maxx Brushless Edition 3908L

  • Page 1 MODEL 3908L MODEL 3908 owner s manual ’...
  • Page 2 Radio Frequency (RF) Exposure Information The radiated output power of the Traxxas LP Device is below the Industry Canada (IC) radio frequency exposure limits. The antenna for this transmitter must not be co-located with any other transmitters except in accordance with FCC and Industry Canada multi-transmitter procedures. Co-location means having a separation distance of less than 20 cm between transmitting antennas.

  • Page 3: Before You Proceed

    1100 Klein Road All of us at Traxxas want you to safely enjoy your new model. Operate model. Failure to follow these instructions will be considered your model sensibly and with care, and it will be exciting, safe, and fun Plano, Texas 75074 abuse and/or neglect.
  • Page 4 It carries our batteries. Make sure you understand how to use your LiPo batteries. (Such as the Traxxas EZ-Peak Plus Charger #2933 or the 2-Cell /3-Cell LiPo expert skill level rating and is intended aware that Traxxas shall not be liable for any special, indirect, incidental, Balance Charger) to charge LiPo batteries.
  • Page 5 SAFETY PRECAUTIONS Charging packs in series or parallel may result in improper charger cell • If a battery gets hot to the touch during the charging process (temperature recognition and an improper charging rate that may lead to overcharging, greater than 110°F / 43°C), immediately and disconnect the battery from cell imbalance, cell damage and fire.
  • Page 6 E-MAXX BRUSHLESS EDITION OVERVIEW Electronic Speed Control Pinion Gears Hex Hub Pivot Ball Axle Carrier Half Shaft Traxxas High- Current Connector Toe Link Battery Hold-Down Toe Link Rear Body Mount Battery Compartment Front Suspension Arm Skid Plate Motor Spur Gear...

  • Page 7: Tools, Supplies And Required Equipment

    TOOLS, SUPPLIES AND REQUIRED EQUIPMENT Your model comes with a set of specialty metric tools. You’ll need to purchase other items, available from your hobby dealer, to operate and maintain your model. For more information on batteries, see Use the Right Supplied Tools and Equipment Batteries on page 12.

  • Page 8: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.

  • Page 9: Radio System

    It happens for a very short period as the signals from the electronic speed control and the motor Your model includes the latest Traxxas TQi 2.4GHz transmitter with Applying the Decals synch with each other. The VXL-3m is optimized to virtually Traxxas Link ™...
  • Page 10 When flow is constricted, energy is converted to heat and is voltage corresponds to the pressure that is forcing the water Correct lost. Traxxas power systems are optimized to reduce electrical through the hose. resistance and the resulting power-robbing heat.

  • Page 11: Transmitter And Receiver

    Case Size ......... 2.2" x 1.9" x 1.4" Weight with Wires ..........121g Connector Type ........6.5mm bullet Power Switch Battery Compartment E-MAXX BRUSHLESS • 11 ** Accessory sensor port for use with TQi Docking Base (see Traxxas.com and included materials for more information)

  • Page 12: Installing Transmitter Batteries

    The power indicator 3. Plug your Traxxas Power Cell 3-cell LiPo into the charger using light does not indicate the charge level of the battery pack its balance plug. All 3 LEDs will glow steady red. Do not leave installed in the model.

  • Page 13: Installing Battery Packs

    Secure, configured for stick packs long-lasting, and easy to grip, the Traxxas connector is engineered to from the factory. The extract all the power your battery has to give.

  • Page 14: Radio System Basic Adjustments

    • Always turn on the transmitter before plugging in the battery. RADIO SYSTEM BASIC ADJUSTMENTS Throttle Neutral Adjustment The following Traxxas High The throttle neutral adjustment is located Current Connector packages Neutral on the transmitter face and controls the are available from your hobby dealer.

  • Page 15: Using The Radio System

    TRAXXAS TQ RADIO SYSTEM USING THE RADIO SYSTEM 2. Have a friend hold the model. Make sure hands and clothing are clear of the wheels and other moving parts on the model. The TQi Radio System has been pre-adjusted at the factory. The...

  • Page 16: Setting Up The Antenna

    TRAXXAS TQ RADIO SYSTEM Steering Sensitivity (Exponential) that favor sweeping turns where gentle steering inputs are required. The Multi-Function knob on the TQi transmitter has been The ranges are exaggerated for illustrative purposes. To prevent loss of radio range programmed to control Steering Sensitivity (also known as...

  • Page 17: Adjusting Electronic Speed Control

    ADJUSTING THE ELECTRONIC SPEED CONTROL The Castle Creations Mamba Monster speed control should ATTENTION! LiPo Battery Users not need reprogramming with normal use. However, if you The E-Maxx Brushless Edition is programmed at the factory for use The Power System is NOT install a different radio system in your model, or change the with LiPo batteries.

  • Page 18: Driving Your Model

    DRIVING YOUR MODEL Now it’s time to have some fun! This section contains instructions the correct initial setting for break-in. Follow these steps to ensure on driving and making adjustments to your model. Before you go maximum performance and life from your slipper clutch: on, here are some important precautions to keep in mind.
  • Page 19 4. Apply small bead of silicone grease • Vary your speed. Continuous high-speed, high-gear running (Traxxas part #1647) to the wire clamp. shortens the run time on the E-Maxx. 5. Install the wire clamp and tighten the •...

  • Page 20: Tuning Adjustments

    TUNING ADJUSTMENTS SUSPENSION TUNING We recommend using two-hole pistons with a range of oil viscosities from 30W to 50W Adjusting the Pivot Ball Caps For easier access to the (available from your hobby shop). The thinner The pivot ball caps should be adjusted rear-most shock mounting viscosity oils (30W or less) flow with less so that the pivot balls operate freely in...
  • Page 21 (A) to position (B). position of the shocks will allow for lower shock progression and the soft, plush feel that’s characteristic of a Traxxas Maxx Truck. Ride height is not affected by changes in the upper shock mounting position.

  • Page 22: Alignment Settings

    (the direction is same carriers adjust the static camber. The pivot at all four corners). Note that Traxxas cannot recommend the use of other non-Traxxas wheels balls are protected by blue dust plugs. To the groove in the hex indicates with different specifications.

  • Page 23: Motor/Gearing

    Visit your local dealer or Traxxas.com for more information. revolution of the tire. Higher numerical ratios provide more torque, Adjusting Gear Mesh Spur Gear lower numerical ratios provide more top speed.

  • Page 24: Dual Steering System

    E-Maxx. Optional steering servo horns are sold center line of the chassis (pointing to the rear of the truck). separately for use with non-Traxxas servos. 7. Connect the short steering link from the servo saver to the servo horn.

  • Page 25: Maintaining Your Model

    5. Check the mounting of the receiver and servo(s) and overtightening. If the bottom of the shock is leaking, then it speed control. is time for a rebuild. The Traxxas rebuild kit for two shocks is 6. Check the tightness of the wheel nuts with a wrench. part #2362.

  • Page 26: Tq I Advanced Tuning Guide

    The TQi radio system automatically keeps track of what vehicles it has bound iPod touch 2nd & 3rd Generation 4mm + 3mm (7mm total) to and what settings were used for each--up to 30 models total! Traxxas Link iPod touch 4th Generation 4mm + 3mm + 2mm (9mm total)
  • Page 27 Many When the Multi-Function knob is set to device and the Traxxas Link application. All the features described racers set Dual Rate so they have only as much steering throw as...
  • Page 28 Press SET to delete the model. Press and hold MENU to Setting Lock turn them on and drive. With Traxxas Link Model Memory, return to driving mode. Once you’ve adjusted all of these settings the way you like...

  • Page 29: Menu Tree

    3. Press SET. The red LED will blink in single intervals to indicate Steering Dual Rate has been selected. Model Locking Press Unlock Traxxas-Link Press 4. Press MENU twice. The red LED will blink three times repeatedly to One Blink Green One Blink Red Four Blinks Green indicate Steering Percentage has been selected.
  • Page 30 ADVANCED TUNING GUIDE Set Multi-Function MENU TREE FORMULAS knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the menu tree, turn your transmitter on, find the function in the...
  • Page 31 1100 Klein Road, Plano Texas 75074 1-888-TRAXXAS 120917 3908OM-LN-EN-R00...

This manual is also suitable for:

E-maxx 3908E-maxx brushless edition3908lE-maxx brushless edition 3908

Table of Contents