Digi Transport Wr11 Command Line Interface (Cli) - Digi TransPort WR11 Installation Manual

Digi TransPort WR11 Cellular Configuration (GSM)
To configure the Mobile interface on GSM routers (GPRS/UMTS/HSPA), make sure an activated SIM is
installed in SIM slot 1 and perform the following steps:
1. Browse to Configuration - Network > Interfaces > Mobile > Mobile Settings.
2. Enter the Service Plan / APN provided by your mobile carrier.
3. Enter optional information such as Username, Password and/or SIM PIN as required by your cellular
provider.
4. Click Apply and Save All.
5. If the TransPort does not obtain a MobileIP address as displayed on the home page, refer to Application
Note QN02 and other documentation at www.digi.com/support.
6. To maintain a reliable cellular connection, it is recommended to enable Dead Link Detection on the
mobile interface. The SureLink Wizard, located in the Wizard section of the WebUI, will walk you through
the configuration. For additional information on this feature, refer to Application Note AN07 available at
www.digi.com/support.

Digi TransPort WR11 Command Line Interface (CLI)

The Command Line Interface (CLI) can be accessed via Telnet and SSH using the IP address of the device.
You can do this using an application such as PuTTY (www.putty.org). Log in using your WR11 username and
password.
CLI Notes
• To view the current configuration settings, enter the command CONFIG C SHOW.
• To save changes made to the device, enter the command CONFIG 0 SAVE.
• All entered commands will take effect immediately.
• All commands supported on the CLI are described in detail in the
the support site.
Digi TransPort WR11 Communications Settings
The default IP address of the device is 192.168.1.1 and it is configured to act as a DHCP server on the Ethernet
interface. This means the WR11 will assign an IP address to a network device, such as a PC, connected to
the Ethernet interface. The connected device must be configured to obtain an IP address automatically using
DHCP.
Digi TransPort WR11 Network Settings
To configure the device with an IP address as part of an existing network, use the following commands.
Note: The DHCP server will still operate unless it is disabled.
Command
ETH 0 IPADDR XXX.XXX.XXX.XXX
ETH 0 MASK XXX.XXX.XXX.XXX
As an example, to assign the IP address 192.168.10.254/24, enter the following commands.
ETH 0 IPADDR 192.168.10.254
ETH 0 MASK 255.255.255.0
Digi TransPort ® WR11 Installation Guide
Description
Sets the Eth 0 IP address
Sets the Eth 0 subnet mask
Page 10
DigiTransPort User Guide available on