Message Lists; Operation Messages; Warning Messages; Error Messages - Tascam CD-200iL Owner's Manual

6 – Message Lists

Operation messages

Depending on the operation of the unit, the following messages will appear in the main display area.
Message
-AUX- AUX IN is selected as the current source.
-CLEAR- All programs have been cleared.
CLOSE The disc tray is closing.
-DOCK- is selected as the current source.
-DOCK-
DOCK---- No iPod or iPhone is connected to the dock.
An iPod or iPhone with a 30-pin Dock connector is connected to
DOCK-30-
the dock.
An iPod or iPhone with a Lightning connector is connected to
DOCK-LT-
the dock.
NO DISC There is no disc or the disc cannot be verified.
NO FILES The data CD has no files that can be played back.
NO NAME There is no artist data or no file data that can be displayed.
NO TITLE There is no title data that can be displayed.
OPEN The disc tray is open.
TOC READ TOC information is being read.

Warning messages

If an operation cannot be completed, one of the following messages will appear for about two seconds and then disappear.
Message
NO PGM No program has been created.
PGM FULL No more tracks can be added to the program.

Error messages

If one of the following error messages is shown, please refer to the Response column and try to resolve it. If you are still unable to correct
the problem, please contact the nearest retailer or TASCAM representative.
Message
COMM ERR
Cannot communicate with the CD drive.
(Blinking)
COMM ERR An error occurred during communication with the CD drive.
DEC ERR The file type is not supported or otherwise could not be played.
The TOC or file system could not be read, or focus adjustment
DISC ERR
was not possible.
DRV ERR The CD drive hardware is broken.
READ ERR The song cannot be accessed.
28
TASCAM CD-200iL
Meaning
Meaning
Meaning
Response
If this message appears even when an iPod or iPhone
is connected, disconnect that iPod or iPhone from the
iPod dock for a few seconds and then reconnect it to
the dock.
Load a disc that contains playable files.
Only 7-bit ASCII-compatible characters can be
displayed as text information.
Only 7-bit ASCII-compatible characters can be
displayed as text information.
Response
Add tracks to the program.
A program can contain a maximum of 99 tracks. Clear
tracks from the program and try again.
Response
Contact the nearest retailer or TASCAM representative.
Contact the nearest retailer or TASCAM representative.
Change the data CD.
Clean or change the disc.
Contact the nearest retailer or TASCAM representative.
Clean or change the disc.