iKarus Eco 7 User Manual

Ikarus eco 7 rc helicopter user's manual

Hide thumbs Also See for Eco 7:

Instruction manual (35 pages)

Table Of Contents

Quick Links

Bedienungsanleitung

User's Manual

Notice d'utilisation

Table of Contents

Need help?

Do you have a question about the Eco 7 and is the answer not in the manual?

Questions and answers

Summary of Contents for iKarus Eco 7

Page 1 Bedienungsanleitung User‘s Manual Notice d’utilisation...
Page 2: Table Of Contents
ﬂ ight battery with the battery charger enclosed. 2. If you have purchased an Eco 7 set without a transmitter, keep in mind that a standard-sized single conversion crystal (not included) still has to be inserted into the receiver (see. Chapter V.8 Remove Gigatronic).
Page 3 Further claims such as for consequential damages are entirely excluded. No warranty claim will be accepted if the item or model has failed due to an accident, incompetent handling, alterations, incorrect or commercial use. The use of any non-Ikarus parts is voiding the warranty.
Page 4: Quick Introduction
However, this should be performed only with the ﬂ ight battery unplugged. 5. Afﬁ x the ﬂ ight battery inside the Eco 7 diagonally, using the rubber strap with the holes and pull it over the top of the battery and secure it to the pin provided for that purpose at the landing gear strut.
Page 5: The Eco 7 - Electronics
II. ECO 7 ELECTRONICS All operating parameters are saved inside the GigaTronic of the ECO 7. This ensures that every model, indepen- dent of the transmitter, (most transmitters of other manufacturers can be used as well) has its optimal operating environment, eliminating the complex task of setting up the transmitter .
Page 6 When replacing the rotor blades or after prolonged operation of the ECO 7, it may become necessary to adjust the blade tracking. Slowly accelerate and increase the turning speed to the point when the ECO 7 is just about to take off, but does not.
Page 7: Flying With The Eco
Turn on the transmitter ﬁ rst, and then plug in the charged battery. Next put down the ECO 7 with its front (nose) facing the wind and away from you. Then accelerate slowly until the copter starts “ﬂ oating” on the ﬂ oor, that is, until it gets lighter.
Page 8 IV. GIGA-TRONIC TS1 Servo �� TS2 Servo TS3 Servo Tail Servo Extra 1 Servo GIGATRONIC QUICK INTRODUCTION Extra 2 Servo Hall Sensor Gyro drift correction Tail PWM Main PWM/Servo Preparation: • Model on the ground. Motors off. • Tail stick all the way to the left. After approx. one second; “CONFIRM.” Gyro is newly adjusted, veering off by the tail is minimized.
Page 9 Programming: • Plug in receiver battery. LED ﬂ ashes red. • Push both transmitter control sticks into any corner and hold. • Turn on transmitter; wait for “CONFIRM.” • Release control sticks and move pitch to minimum position; “CONFIRM.” • Tail stick all the way to the right;...
Page 10 V. DISASSEMBLING AND MAINTENANCE 1. DISASSEMBLING THE ROTOR HEAD �� In order to be able to disassemble the mechanics, the rotor head must be separated from the rotor shaft ﬁ rst. Here, ﬁ rst remove the rotor blades using the proper tools. Remove the Hiller pushrods from the ball of the ﬂ...
Page 11 4. DISASSEMBLING THE TAIL BOOM If the tail has to be removed, turn the bayonet joint of �� the tail boom to the right and separate it from the fuselage. In the process also carefully pull the cable out of the fuselage. ��...
Page 12: Servo Installation
Servo installation �� Servo Adjustement...
Page 13 6. REMOVAL AND CHANGING SERVOS Roll servos front right and left Pull servo plug off of electronics (remember servo plug location). Remove servo pushrod from swash plate, unlock the servo by pushing it in arrow direction and remove it from the mechanics (see “Servo installation“...
Page 14 7. CHASSIS AND ROTOR SHAFT After the rotor head has been removed, the rotor shaft collar can be detached and the main rotor shaft can be � pulled downwards out of the chassis. Now press on the shaft so you can remove the cross pin out of the gear hol- der and pull the main gear off the shaft.
Page 15 9. REMOVE MOTOR �� Loosen screws No.3 and detach motor 10. GEAR MESH ADJUSTMENT Loosen front chassis screw No.1. �� Adjust gear mesh by twisting the motor (Excenter). Loosen screws No.3 and take off motor. Screw motor back in. Refasten front chassis screw. ��...
Page 16: Troubleshooting
VI. TROUBLESHOOTING QUESTION POSSIBLE CAUSE EFFECT REMEDY SERVOS AND MOTORS CRYSTALS DEFECTIVE NO SIGNAL AT RECEIVER; REPLACE CRYSTALS DO NOT WORK ELECTRONICS RECOGNIZE THE DEFECT AND DEACTIVATE MOTOR AND SERVOS TRANSMITTER NOT SWIT- SWITCH ON TRANSMITTER CHED ON SERVOS AND MOTORS THROTTLE/PITCH STICK NOT THE ELECTRONICS NOTICE A DE- MOVE PITCH CONTROL STICK TO...
Page 17: List Of Replacement Parts And Exploded Views
VII. LIST OF REPLACEMENT PARTS AND EXPLODED VIEWS Rotor Head �� Qty. Ord. No. Item Description Speciﬁ cations in mm (sorted by ord. no.) 6073007 BLADE HOLDER, 2 PCS. 6073008 SELF TAPPING SCREW, 10 PCS.
Page 18 Mechanics �� Qty. Ord. No. Item Description Speciﬁ cations in mm (sorted by ord. no.) 6073001 COVER FOR ELECTRONICS BOX 6073002 ELASTIC BATTERY STRAP, 2 PCS.
Page 19 LANDING GEAR SKIDS W/ ANTISKID INSERTS 6073051 ANTISKID INSERTS, 10 PCS 6073090 CHASSIS HOLDING RAIL, FRONT & REAR 6073091 ECO 7 JET RANGER TAIL SECTION 6073092 ECO 7 JET RANGER FRONT SECTION 6073093 COMPLETE FRONT FUSELAGE W/ DECAL 6073094 COMPLETE REAR FUSELAGE W/ DECAL...
Page 20: Tail Boom
Tail Boom �� Qty. Ord. No. Item Description Speciﬁ cations in mm (sorted by ord. no.) 6073008 SELF TAPPING SCREW, 10 PCS. 2,9 x 9,5 6073022 FRONT PART TAIL CONNECTOR 6073023 REAR PART TAIL CONNECTOR 6073028...
Page 21 Servo Pushrods �� Qty. Ord. No. Item Description (sorted by ord. no.) 6073032 FLYBAR PUSHRODS, 2 PCS. 6073061 COMPLETE SWASHPLATE 6073062 SERVO PUSHROD SET TYPE 1, 3 PCS. 6073089 SERVO HOLDING CLAMP SET TYPE 1, 3 PAIRS...
Page 22: Accessories
Our batteries have been factory tested . Since we have no inﬂ uence on the handling of the batteries, we do not offer any warranty on the batteries. THE ECO 7 COMES INSIDE A PRACTICAL CARRYING CASE FOR THE HELICOPTER, TRANSMITTER, BATTERIES, BATTERY CHARGER, TOOLS, ETC.

iKarus Eco 7 User Manual

Quick Links

Need help?

Questions and answers

Related Manuals for iKarus Eco 7

Summary of Contents for iKarus Eco 7