Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Gefen GTB-HDMI-3DTV
Summary of Contents for Gefen GTB-HDMI-3DTV
- Page 1 Gefen Extender ® for HDMI 3DTV GTB-HDMI-3DTV GTB-HDMI-3DTV-BLK User Manual...
- Page 2 Notice Gefen, LLC reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. GefenToolBox Extender for HDMI 3DTV is a trademark of Gefen, LLC HDMI, the logo, and High-Defi...
-
Page 3: Table Of Contents
CONTENTS Introduction Operation Notes Features Sender Unit Layout Sender Unit Descriptions Receiver Unit Layout Receiver Unit Descriptions Connecting and Operating The Extender For HDMI 3DTV DIP Switch Configuration 11 Network Cable Wiring Diagram 12 Wall Mounting Instructions 13 Specifications 14 Warranty... -
Page 4: Introduction
INTRODUCTION ® Congratulations on your purchase of the Extender for HDMI 3DTV. Your complete satisfaction is very important to us. GefenToolbox GefenToolbox is a unique product line catering to the growing needs for innovative home theater solutions. We specialize in total integration for your home theater, while also focusing on going above and beyond customer expectations to ensure you get the most from your hardware. -
Page 5: Operation Notes
OPERATION NOTES READ THESE NOTES BEFORE INSTALLING OR OPERATING THE EXTENDER FOR HDMI 3DTV • CAT-5 or CAT-6 cables should not exceed 330 feet (100 meters). • Shielded (STP) CAT-5 or CAT-6 is recommended. However, unshielded (UTP) CAT-5 or CAT-6 is acceptable. •... -
Page 6: Features
FEATURES HDMI 1.3 Features • 225 MHz (up to 12-bit YUV 4:4:4 @ 1080p60) • Deep Color • Dolby TrueHD and DTS-HD Master Audio • Lip-Sync • CEC Pass-Through Features • Extends HDMI at 1080p up to 330 ft (100 m). •... -
Page 7: Sender Unit Layout
SENDER UNIT LAYOUT Left Right... -
Page 8: Sender Unit Descriptions
SENDER UNIT DESCRIPTIONS CAT-5 Output Jack Connects the Sender to the Receiver unit using CAT-5 cabling. IR Blaster Port Connect an IR Blaster cable from this port to the Hi-Def source to control the source from the viewing location (IR Blaster not included). 5V DC Locking Power Connector Connect the included 5V DC locking power supply to this connector. -
Page 9: Receiver Unit Layout
RECEIVER UNIT LAYOUT Left Right... -
Page 10: Receiver Unit Descriptions
RECEIVER UNIT DESCRIPTIONS IR Extender Port Connect an IR extender to this port. CAT-5 Input Port Connects the Receiver to the Sender unit using CAT-5 cabling. IR Sensor Receives signals from the 3D source IR remote control. The IR signals are sent back to the source device, when using an IR Blaster on the Sender. -
Page 11: Connecting And Operating The Extender For Hdmi 3Dtv
NOTE: If the source and display support 3D then the Extender for HDMI 3DTV will pass through the 3D signal. Wiring Diagram for the Extender for HDMI 3DTV CAT5 LINK CABLE (Up to 330 ft) HDMI CABLE Set-top Box Receiver Receiver IR Blaster Sender HDMI Display GTB-HDMI-3DTV... -
Page 12: Dip Switch Configuration
DIP SWITCH CONFIGURATION DIP Switch Location On the bottom of the Extender for HDMI 3DTV Receiver unit there are four (4) DIP switches. The DIP switches allow advanced EDID management of the Extender for HDMI 3DTV which may be necessary when troubleshooting or using different brands of hardware. - Page 13 DIP SWITCH CONFIGURATION DIP 1 - EDID Mode ON (default) - External EDID Mode • DDC and HPD are passed through. Both the connection status and the full A/V capabilities of the display. The HPD status will also be detected by the source device.
-
Page 14: Network Cable Wiring Diagram
NETWORK CABLE WIRING DIAGRAM Gefen recommends the TIA/EIA-568-B wiring option. Please adhere to the table below when fi eld terminating cable for use with Gefen products. Color Orange / White Orange Green / White Blue Blue / White Green Brown / White... -
Page 15: Wall Mounting Instructions
WALL MOUNTING INSTRUCTIONS The GefenToolbox Extender for HDMI 3DTV should be mounted vertically on a wall or inside / outside a cabinet with wood / drywall screws as shown in the diagram above. There should be an inch or two of clearance between the edges of the unit and any walls or vertical surfaces to allow for enough clearance for connection and disconnection of the HDMI cable. -
Page 16: Specifications
SPECIFICATIONS Video Amplifi er Bandwidth.................225 MHz Input Video Signal..................1.2 V p-p Input DDC Signal................5 V p-p (TTL) Maximum Video Resolution........1080p, supports 3D HDMI signals HDMI Input Connector..............Type A 19-pin (F) Link Connector.................RJ-45 Shielded Power Indicator..................LED (red) Dimensions...............4.5” L x 3.25” W x 1.0” H Power Supply....................5 V DC Power Consumption..............10 W per unit (max.) Operating Temperature ................0 - 40 °C... -
Page 17: Warranty
Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notifi ed within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifi... - Page 19 Rev A5 29.6 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefentoolbox.com support@gefentoolbox.com...
Need help?
Do you have a question about the GTB-HDMI-3DTV and is the answer not in the manual?
Questions and answers