Table of Contents
Advertisement
Quick Links
Spa Bath Installation and Operation Instructions
Dear Purchaser/Installer
Thank you for purchasing a Clearlite Bathrooms product. We are proud to be 100% NZ owned and operated
with over 30 years experience in the bathroomware industry. We hope you enjoy your Clearlite Bathrooms
experience.
The unit that you have purchased has been designed and manufactured to the highest possible standards.
Please read and ensure that you fully understand the installation instructions and how they apply to your unit.
Bear in mind that useful old adage - "measure twice and cut once".
Please note that prior to wrapping this product it was cleaned and polished under bright lights.
For your own peace of mind please unwrap and check the product carefully on receipt. This is a precaution to
ensure that the product has not been damaged by handling or transport. No claim will be recognised
regarding face damage to the product anytime after installation.
Whilst we at Clearlite Bathrooms take great pride in producing what we consider the best products available,
we cannot accept responsibility for damage that may occur in handling or installation.
All Clearlite Bathrooms Spa Baths are supplied with a self-supporting wooden
frame for easy installation and have been extensively factory water tested prior
to dispatch. Please check the screw connections of the pipe work (as indicated
on the product) as these can sometimes work loose during transportation.
All Clearlite Bathrooms Spa Baths are manufactured to the highest standard and
are designed to provide maximum therapeutic benefits. As a standard feature
Clearlite Bathrooms Spa Baths are fitted with a heated pump. The heating can be
manually controlled from the safety and comfort of the bath, its function is to
maintain the water temperature, removing the need to add hot water whilst
bathing. It is not designed to heat water from cold.
Installer - Please make the "Operating Guide" section of this
Important Note
document available to the Homeowner
Advertisement
Table of Contents
Summary of Contents for Clearlite Bathrooms Spa Bath
- Page 1 Spa Bath Installation and Operation Instructions Dear Purchaser/Installer Thank you for purchasing a Clearlite Bathrooms product. We are proud to be 100% NZ owned and operated with over 30 years experience in the bathroomware industry. We hope you enjoy your Clearlite Bathrooms experience.
-
Page 2: Water Testing
Spa Bath Installation Guide Location First check that there will be adequate pump access before proceeding with installation. A minimum of 300mm square unobstructed clearance is needed if pump servicing or removal is necessary. If sufficient room is not made available the equipment warranty will be nullified. When the bath is located in the correct position and the bottom of the bath is fully supported by the floor and is sitting level, fix bath in place, connect the waste outlet and fit taps. -
Page 3: Jet Options
Operation Guide For A Clearlite Spa Bath (Hydro or Whisper Jets) When filling the bath it is recommended to partially fill with cold water to allow the bath to gradually adapt to the temperature. Also the heated pump features a safety protection device, which cuts out the heater if water temperature exceeds 50 degrees. - Page 4 Lumbar & Foot Mini Jets only Position 2: Whisper Jets, Lumbar & Foot Mini Jets Position 3: Whisper jets only For further information contact: Telephone: (09) 444 3780 Clearlite Bathrooms Facsimile: 0800 88 00 11 54-58 Hillside Road Email: info@clearlite.co.nz Private Bag 40902 Glenfield Website: www.clearlite.co.nz...
Need help?
Do you have a question about the Spa Bath and is the answer not in the manual?
Questions and answers
How do make the spa bath stay the jets while bathing