Maintaining Your Water Bee; Checking Your Bearings; Draining Water From Your Water Bee - Future Beach WB 200 Owner's Manual And Assembly Manual

Water Bee Pedal Boat
™
IV. Maintaining your Water Bee Pedal Boat
A) Bearing Inspection
Future Beach recommends that the owner check the bearings every 2-3 months in coarse sand,
and salt-water conditions. To check the bearing:
1. Using your 3/4" ratchet,
remove the bolt from the
crankshaft. (Note: to
remove the bolt, use vice-
grips to hold bolt on other
side in place)
B) Draining water from your Water Bee pedal boat
Although your Water Bee is roto-molded, in the case that water has somehow managed to enter
inside your hull, it is important to remove it before storing and/or reusing.
1. Locate the two drain
plugs at the rear of your
pedal boat
Future Beach Corporation
™
The World's Beach Company
2. Pull away crankshaft
away from bearing in
order to access the
bearing.
2. Using a file, or
flat screwdriver,
unscrew the drain
plugs.
™
Owner's Manual and Assembly Guide
3. Now the bearing may
be accessed and inspected
for grit, dirt, and any other
contaminants that may
cause damage to the drive
system.
3. Stand boat up against a wall
to let water drain from the
drain plugs removed in steps
1-2. Locate and remove drain
plugs on the underside of the
pedal boat.
9