Table of Contents
Advertisement
Quick Links
Fan-Assisted Radiator
Installation & User Guide
Dear Installer,
The following items should be included in the carton:
• Product
• Transformer with 450mm of pre-wired mains cable
• 2 single-pin male connectors
In the event of items missing or visible damage please
contact us on 01245 324560. We would be most grateful
if you would leave this Installation & User Guide and the
Guarantee Registration Card with the owner of the
property.
Thank you for your co-operation.
Steve Russell
Customer Service Manager
Sterling
STR7-12V
Advertisement
Table of Contents
Related Manuals for Smith's Heating First STR7-12V
Summary of Contents for Smith's Heating First STR7-12V
- Page 1 Sterling Fan-Assisted Radiator STR7-12V Installation & User Guide Dear Installer, The following items should be included in the carton: • Product • Transformer with 450mm of pre-wired mains cable • 2 single-pin male connectors In the event of items missing or visible damage please contact us on 01245 324560.
- Page 2 Introduction Sterling 12V is primarily intended for installation directly onto a wall at high level in bathrooms and other high humidity areas. The maximum recommended installation height is 2.1 metres to the underside of the heater. There is no clearance required above or to the side of the heater.
- Page 3 Installation 1. Release the outer casing by removing the screws on the underside of the casing. 2. Secure the heater to the wall using fixings suitable for the wall type. Ensure the chassis is flat wall level. necessary packing compensate for an uneven wall surface.
- Page 4 4. Isolate the electrical supply and connect the transformer to the fused spur. The transformer must be located outside the bathroom or high humidity area. Connect the single pin male connectors to the twin core cable you have supplied. 5. Push in the connectors to the transformer terminals connect the other end of the...
- Page 5 Heat Output Normal Boost Model Watts Btu/h Watts Btu/h STR7-12V 1351 4611 1801 6148 The temperature of the water in the central heating system will affect the heat output of the Sterling model. The heat outputs given are tested in accordance with BS 4856 using a water temperature of 85°C (185°F) at a flow rate of 340 lph (75 gph) and 20°C (66°F)
-
Page 6: Fault Finding
In the event of difficulty please contact us on 01245 324560. It will be helpful if you do not disconnect the heater from the central heating system. Smith's Environmental Products Ltd, Blackall Industrial Estate, South Woodham Ferrers, Chelmsford, Essex CM3 5UW Tel: 01245 324900 After Sales: 01245 324560 Fax: 01245 324422 E-mail: info@smiths-env.com Web: www.smiths-env.com... -
Page 7: User Guide
Sterling Fan-Assisted Radiator STR7-12V User Guide Dear Customer, We are delighted you have chosen one of our products and trust you are satisfied with the installation. We would ask you to take a few minutes to read the User Guide to help you gain maximum benefit from your Sterling fan-assisted radiator. - Page 8 01245 324560. It will be helpful if you do not disconnect the heater from the central heating system. Smith's Environmntal Products Ltd, Blackall Industrial Estate, South Woodham Ferrers, Chelmsford, Essex CM3 5UW Tel: 01245 324900 After Sales: 01245 324560 Fax: 01245 324422 E-mail: info@smiths-env.com Web: www.smiths-env.com...
Need help?
Do you have a question about the STR7-12V and is the answer not in the manual?
Questions and answers