Chapter 1
Component Name/LED Name
1.4
Components (Rear)
2.
DRIVE FAULT LED
Figure 1.5 Drive Slot Numbers
The states of LEDs are listed below.
Table 1.2 Status and Meanings of Each LED (Drive)
LED name
DRIVE READY
DRIVE FAULT
1.4
Components (Rear)
This section describes the controllers and the power supply units in the rear of the controller enclosure.
■
Controllers
The controller contains a CPU, cache memory, System Capacitor Unit (SCU), host interfaces, and LAN ports.
The controller controls all operations in the ETERNUS DX.
Figure 1.6 Controllers
1
11
1.
PWC port
This port is used to connect a power synchronization unit with an RS232C cable.
2.
LAN (RMT) port
These are the RJ-45 connectors to connect LAN cables.
3.
LAN (MNT) port
These are the RJ-45 connectors to connect LAN cables.
LED status
(green)
(blinks green)
(amber)
2
6 7
11
12 13
4
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Meaning
The drive is in normal status.
•
The drive is in error status.
In response to commands from ETERNUS CLI, the location of
•
the drive is identified.
3
8
9
10
11
11
12 13
5
15
P3AM-8472-01ENZ0