Related Manuals for Wadia 321
Summary of Contents for Wadia 321
- Page 1 Wadia Digital, LLC. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3539 Fax: 607-724-0549 www.wadia.com 321decoding computer Owner’s Manual...
-
Page 2: Safety Instructions
The lightning flash with arrowhead, within an equilateral The exclamation point within an equilateral triangle is triangle, is intended to alert the user to the presence of intended to alert the user to the presence of important uninsulated “dangerous voltage” within the product’s en- operating and maintenance (servicing) instructions in the closure that may be of sufficient magnitude to constitute literature accompanying the appliance. -
Page 3: Temporarily Place It Aside. Refer To Figures 2 And
Battery tery disposal. Batteries should never be Points thrown away or incinerated. Battery Installation The Wadia 321 Remote Control uses a long life Lith- CR2032 ium Coin Cell type battery. The 321 may be supplied Figure 4 Figure 5 WARNING... -
Page 4: Table Of Contents
Thank You Please Take A Moment Table of Contents All of us at Wadia Digital would like to say thank you, The serial number, purchase date and Wadia Dealer Safety Instructions ............. 2 Battery Installation and Replacement ......3 and congratulations for deciding to own this Wadia name are important to you for possible insurance 321decoding computer. -
Page 5: General Information
321decoding computer. 6. When discarding the unit, comply with local rules 2. The Main AC Power going to the 321 and any other or regulations. Batteries should never be Wadia Component(s) should not be applied until thrown away or incinerated but disposed all the system components are connected together. -
Page 6: Introduction
Power Transformer ensure stable noise free operation lution. even though the power line varies. Note: The Wadia 321 is designed to be compatible with the majority of Audio Power Amplifiers. However, • Gold Plated Connectors do to a wide range of Power Amplifier Designs it is... -
Page 7: Dimensions
Dimensions Dimensions The following dimensions can assist in determin- ing the best location for your 321. There is additional information on the next page pertaining to installing the 321 into cabinets. Front View of the 321 " 45.4cm " "... -
Page 8: Installation
321 Front View 2.5cm 2.5cm the top, 5/8 inches (1.6cm) below the bottom and 1 inch (2.5cm) on each side of the 321, so that airflow is not obstructed. Allow 20 inches (50.8cm) of depth for airflow and cable connections. 2"... -
Page 9: Rear Panel Connections
Rear Panel Connections Connect the Wadia 321 power cord to a UNBALANCED AUDIO OUTPUTS analog live AC outlet. Refer to information on audio output signals to a Preamplifier or A/V the back panel of your 321 to determine Control Center... -
Page 10: Connecting To A Preamplifier
There are two different ways the 321 may be operated in an audio system. The first way is as a Digital to Analog Converter with Input Switching. The Audio Output of the 321 is connected to an Analog Input on AUDIO OUTPUT the Preamplifier (Integrated Amplifier or Receiver). -
Page 11: Connecting To A Power Amplifier
Connecting to a Power Amplifier Connecting to a Power Amplifer The 321 may also be used as the Main Audio Pream- plifier connected directly to a Power Amplifier. Folow POWER AMPLIFIER the connection instructions below and diagram on this page. -
Page 12: Remote Control Push-Buttons
Remote Control Push-Buttons Press MODE to switch power On or Off to the 321 Steps thru the Digital Inputs (1 - 5) for source selection Press DISPLAY to adjust brightness of the 321 Front Mutes the audio Panel Display Press the (+) or (-) to adjust the... -
Page 13: Front Panel
Operational Functions and Setup Mode Settings (1 - 5) for decoding Increases the Volume Level SETUP Push-button with STANDBY/ON Push-button indicator, activates the with indicator, switches the Setup Mode for changing 321 ON or OFF (Standby) operational settings Decreases the Volume Level... -
Page 14: Setup
ENABLED while performing the following steps. FIRMWARE V_ _.__ Note: If the 321 is currently On, proceed to step 2. Firmware Version 1. Press the STANDBY/ON Push-button on the Front Auto Power Off Panel or press the MODE (Power) Push-button on The 321 functionality is controlled by internal soft- the Remote Control to switch On the 321. -
Page 15: How To Operate The 321
“In Phase”. Occasionally the music may be “Out of and Volume Level Setting. Refer to figures 50, 53, and Note: A Volume Setting of 88% on the Wadia 321 will Phase” and the 321 can correct this out of phase condi- provide optimum performance when it is con- 56. - Page 16 Computer and the Wadia Under “Products” select “Wadia 321” then scroll Product with the USB-Dig- down to the bottom of the Wadia 321 to the “DOWN- Figure 7 ital Audio Input. An Icon LOAD AREA”. Select the “WADIA 321 PC DRIVER will appear On-Screen indicating Windows has found SETUP”...
-
Page 17: Operation
How to Operate the 321, con’t Windows Sound Settings 2. Right mouse button click to bring up the menu For proper operation of the McIntosh Product via the and then select the “Sound and Audio..”. Refer Computer USB Connection, it is required to make to figures 14 and 15. - Page 18 Wadia USB Audio Driver Operation Control Panel Settings It would be an appropriate choice when using a play- The 321 USB Control Panel allows changes to be back program like Windows Media Player. made from the default settings. These include Latency,...
-
Page 19: Photos
Photos... - Page 21 Photos, con’t...
-
Page 22: Specifications
240 Volts, 50/60Hz at 30 watts USB: USB Type B Connector Standby Power, less than 0.25 watts Signal To Noise Ratio (A-Weighted) Note: Refer to the rear panel of the 321 for the correct voltage. 110dB PCM (Pulse Code Modulation) Digital Signal type used for CD Discs, etc. -
Page 23: Packing Instruction
Packing Instructions Packing Instructions In the event it is necessary to repack the equipment for shipment, the equipment must be packed exactly as shown below. It is very important to ensure the proper equipment location between the bottom and top foam pads. - Page 24 Wadia Digital, LLC 2 Chambers Street Binghamton, NY 13903 www.wadia.com The continuous improvement of its products is the policy of Wadia Digital who reserve the right to improve design without notice. Printed in the U.S.A. Wadia Digital Part No. 04146801...
Need help?
Do you have a question about the 321 and is the answer not in the manual?
Questions and answers