Gtech HT04 Safety And Instruction Manual page 9

Connect the charging jack into the socket on the charging stand. Plug the charging adaptor
into a suitable electrical socket and switch on.
Push the battery pack into the charging stand. Press down firmly to ensure the battery pack is
fully located in the charging stand.
Using the Standard Charger:
From flat the battery requires 15 hours to fully charge.
NOTE: There is no indicator on the charger or battery to show when the battery is charging
or fully charged. Charge the battery for 15 hours after use to ensure full charge.
The battery will not be damaged if charged more than 15 hours but should not be charged for
more than 24 hours.
Using the Fast Charger:
From flat the battery requires 4 hours to fully charge.
The red light on the charger will illuminate to show the battery is charging. The light will turn
green when the battery is fully charged.
WARNING: ONLY USE THE CHARGER AS SUPPLIED WITH THE PRODUCT.
USING ANY OTHER CHARGER MAY DAMAGE THE PRODUCT AND THE BATTERY.
Once the battery is fully charged switch off the electrical socket, remove the charging jack
from the battery pack, and unplug the charging adaptor from the mains socket.
WARNING: Do not pull the charging adaptor by the cord.
WARNING: Ensure the start switches are not in the ON position before reconnecting the
battery to the product.
Only use replacement batteries as supplied by the manufacturer.
Spare and replacement batteries can be purchased from Gtech:
01905 345891 support@greytechnology.co.uk
Tel: email:
9
helpline 01905 345891 email support@greytechnology.co.uk web www.gtechonline.co.uk
HT04 GenericManual09QVC.indd 9 23/12/2009 11:25