Advertisement
Janus Elevator Products Inc.
"Sound Innovation, On Call"
HDSICM ONE WAY INTERCOM
USER'S MANUAL
AVAILABLE IN THE U.S. THROUGH
125 Ricefield Lane, Hauppauge, New York 11788
Phone: 631 864 3699 Toll Free: 800 527 9156
Fax: 631 864 2631 Email: sales@januselevator.com
www.electronicmicrosystems.com
www.januselevator.com
Advertisement
Table of Contents
Summary of Contents for Janus Elevator Products HDSICM ONE WAY INTERCOM
- Page 1 Janus Elevator Products Inc. “Sound Innovation, On Call” HDSICM ONE WAY INTERCOM USER’S MANUAL AVAILABLE IN THE U.S. THROUGH 125 Ricefield Lane, Hauppauge, New York 11788 Phone: 631 864 3699 Toll Free: 800 527 9156 Fax: 631 864 2631 Email: sales@januselevator.com www.electronicmicrosystems.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SECTION PAGE FEATURES OPERATION PRE-TESTING INSTALLATION TROUBLESHOOTING WARRANTY POLICY RETURN POLICY... -
Page 3: Features
FEATURES • Complies with the 1996 Code for machine room to cab communications • Simple off-hook operation • Easy installation with one pair wiring • Battery backup • Call is initiated from Machine Room phone only • Wall mounted phone with handset for machine room •... -
Page 4: Pre-Testing
PRE-TESTING 1. Remove intercom system from shipping box. If you want to test the intercom before installation, connect a pair of wires from the white terminal strip to the TELCO block on the cab unit. Be sure that the positive side of the European connector is connected to the positive side of the TELCO block. -
Page 5: Installation
INSTALLATION The intercom system requires one pair wiring for each elevator unit to the machine room phone. The intercom system requires 110 volts AC to trickle charge the battery. The wiring from the AC plug can be extended as needed to get to the nearest outlet. Connectors are provided for this purpose. -
Page 6: Troubleshooting
TROUBLESHOOTING Make sure that the Machine Room phone is getting power from the AC transformer by checking the voltage on the battery snap. There should be approximately 13 volts DC with the handset on-hook. There should be positive voltage on the female side of the connector and negative voltage on the male side. - Page 7 6. You can test each cab unit individually and without any field wiring connected by attaching a 9-volt battery to the battery connector that is soldered directly onto the PC board and plugging a modular tone phone into the black jack on the back of the board.
-
Page 8: Warranty Policy
WARRANTY POLICY Janus Elevator Products Inc. warrants its products to be free from defect in materials and workmanship under normal use and service for 24 months from date of purchase. Seller’s obligation shall be limited to repairing or replacing, at... -
Page 9: Return Policy
RETURN POLICY During installation, if a product does not appear to function properly the installer must call the Janus Elevator Products Technical Support Unit at (800) 527-9156, Monday through Friday. If the technician determines that the product is not functioning, an RA (Return Authorization) number will be issued, allowing the installer to return the product directly to Janus Elevator Products for repair, replacement or credit.
Need help?
Do you have a question about the HDSICM ONE WAY INTERCOM and is the answer not in the manual?
Questions and answers