FLORABEST FGH 710 A1 Operation Manual
Garden cultivator
Hide thumbs
Also See for FGH 710 A1:
- Operation manual (78 pages) ,
- Translation of original operation manual (76 pages) ,
- Original operation manual (67 pages)
Related Manuals for FLORABEST FGH 710 A1
Summary of Contents for FLORABEST FGH 710 A1
- Page 1 FGH 710 A1 ® Garden Cultivator Translation of original operation manual 68654_flo_Gartenkultivator_FGH710A1_Cover_LB6.indd 20 02.11.11 12:59...
- Page 2 Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. GB / IE Translation of original operation manual Page 68654_ o_Gartenkultivator_FGH710A1_Cover_LB6.indd 21 02.11.11 12:59...
- Page 3 23 10...
-
Page 4: Table Of Contents
Contents Safety notes Safety notes .......... 4 This section deals with the basic safety Symbols ..........4 regulations while working with the electric General safety notes ......5 tiller. Functional description ......7 Symbols Functional parts ........8 Intended purpose ........ 8 Assembly instructions ...... -
Page 5: General Safety Notes
Symbols in the manual • This appliance is not intended for use by persons (including children) with Warning symbols with informa- reduced physical, sensory or mental tion on damage and injury pre- capabilities, or lack of experience and vention. knowledge, unless they have been giv- en supervision or instruction concern- Instruction symbols (the instruction ing use of the appliance by a person is explained at the place of the ex-... - Page 6 Working with the tool: • If the chopping knife is blocked by a foreign body, switch off the equipment Keep your hands and feet away and disconnect at the plug. Remove from the tines while working, es- the foreign body (e.g. root) before re- pecially when starting up the tool starting the equipment.
-
Page 7: Functional Description
- If the mains cable is damaged or • Make sure that the mains voltage caught up matches the data on the tool’s rating - If the tool collides with an obstacle label. or starts to vibrate in an unusual •... -
Page 8: Functional Parts
Assembly instructions The major functional parts are shown on the foldout pages. Always disconnect the tool from the mains before conducting any work on it. Functional parts Scope of delivery 1a Right-hand fork grip with dead- man lever, safety release catch Carefully remove the tool from the pack- and cable tension relief aging and check that the following parts... -
Page 9: Operation
When assembled correctly, the Warning! The tines will continue to turn for a few seconds after handle ends point away from the equipment front with the ventila- the tool has been switched off. tion slits (see 7). Do not touch the rotating tines – injury hazard! 4. Fasten the mains cable with the Operating instructions cable clips supplied: - Large cable clip (3a) above the Always keep a firm grip on the cross-plate - Small cable clip (3b) at the... -
Page 10: Cleaning, Maintenance, Storage
Cleaning, maintenance, • Check the covers and guards for dam- storage age and correct fit. Change them if necessary. Warning! Always return the tool to the service centre for work not We shall not be held responsible for any described in the manual. Only use damage caused in any of the following original parts. -
Page 11: Storage
5. Slide the hex bolt through the • Damage caused by natural wear, hole and tighten on the self- overload, or improper use is not cov- locking nut (supplied with each ered by guarantee. Certain compo- new tine wheel pair 23). nents are subject to normal wear and are not covered by guarantee. -
Page 12: Disposal, Environmental Protection
Technical environmental specifications protection Be environmentally friendly. Return the FGH 710 A1 Electric Tiller tool, accessories and packaging to a recy- Motor power input ......710 W cling centre when you have finished with Mains voltage ......230V AC them. -
Page 14: Translation Of The Original Ec Declaration
Translation of the original EC declaration of conformity We hereby confirm that the FGH 710 A1 series electric tiller Serial number 201110000001 - 201112074628 conforms with the following applicable relevant version of the EU guidelines: 2006/42/EC • 2004/108/EC • 2000/14/EC... -
Page 15: Exploded Diagram
Exploded Drawing informative... -
Page 17: Service-Center
Service-Center Service Great Britain Tel.: 0871 5000 720 (£ 0.10/Min.) E-Mail: grizzly@lidl.co.uk IAN 68654 Service Ireland Tel.: 1890 930 034 (0,08 EUR/Min., (peak)) (0,06 EUR/Min., off peak)) E-Mail: grizzly@lidl.ie IAN 68654 2011-11-11-rev02-op... - Page 18 IAN 68654 Grizzly Gartengeräte GmbH & Co. KG Am Gewerbepark 2 D-64823 Groß-Umstadt Last Information Update: 11 / 2011 Ident.-No.: 76005541112011 - 6 68654_flo_Gartenkultivator_FGH710A1_Cover_LB6.indd 19 02.11.11 12:59...
Need help?
Do you have a question about the FGH 710 A1 and is the answer not in the manual?
Questions and answers