Clifford Matrix RS2 Installation Manual page 14

H2/3 VIOLET/BLACK (-) 200 mA Channel
This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 4
is pressed. This output can be programmed to provide the following types of outputs (see also the
Feature Menus section):
➤ ➤ Validity: Output that will send a signal as long as the transmission is received.
➤ ➤
Latched: Output that will send a signal when the Channel 4 button(s) is pressed and will
continue until the same button(s) is pressed again.
➤ ➤
Latched/reset with ignition: This works similar to the latched output, but will also reset (output
will stop) when the ignition is turned on and then off. This output can also be shut off at any
time by pressing the transmitter button that controls Channel 4 again.
➤ ➤
30-second timed: Output that will send a continuous signal for 30 seconds.
➤ ➤
Second unlock output: This output can also be programmed to provide a second unlock pulse
whenever the disarm button is pressed within 15 seconds after disarming the system. This
setting could be used to unlock the passenger doors when installing progressive door locks, for
instance.
NOTE: Programming Channel 4 for second unlock will link the violet/black wire to the unlock
button. Pressing the unlock button once will send the output to the H4/A or H4/C unlock wire.
Pressing the unlock button a second time within 15 seconds will send a negative (-) unlock pulse to
the violet/black wire.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
14
© 2001
Directed Electronics, Inc.