Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Shoreline Hot Tub
- Page 1 ™ HOT TUB OWNER’S MANUAL 2001...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Important Safety Instructions ......................3 Location and Installation .......................4 Hot Tub Set Up ..........................5 Hot Tub Operation ..........................6 Hot Tub Care and Maintenance ....................8 Winterizing ............................9 Water Care ............................10 Ozone ...............................11 GFCI Load Center Wiring ......................12 Troubleshooting ..........................13 Hot Tub and Dealer Information....................15... -
Page 3: Important Safety Instructions
8. DANGER- Risk of Electric Shock. Install at least 5 feet (1.5 m) from all metal surfaces. As an alternative, a hot tub may be in- stalled within 5 feet of metal surfaces if each metal surface is permanently connected by a minimum No. 8 AWG (8.4 mm2) solid copper conductor to the wire connector on the terminal box that is provided for this purpose. -
Page 4: Location And Installation
Since your hot tub water will likely have chemicals in it, you won't want to drain your hot tub on the lawn or into a garden. Be sure you can reach a garden hose from the hot tub to where you plan to drain the water. Never let wa- ter get on the equipment module that is located inside the equipment compartment of your hot tub. -
Page 5: Hot Tub Set Up
WARNING: Do not turn ON the power to the hot tub unless it is filled with water and all valves are open. Be sure water level is at the recommended point. If the power is ON, the system may start even though the controls were not activated. If the equipment module is started without sufficient water in the hot tub, the system could be permanently damaged. -
Page 6: Hot Tub Operation
Refer to the Control Manual operating instructions for the hot tub-side control unit. Your Shoreline Leisure Products™ hot tub comes equipped with a variety of jets and water/air controls. Some of the jets allow you to control the amount of water flow by rotating the face of the jet. Turning the face clockwise will reduce the water flow from the jet and turning it counterclockwise will increase the water flow. - Page 7 To replace the hot tub light bulb, turn off all power to the equipment module. Locate the rear of the hot tub light assembly and unscrew the lamp holder from the clear lens body. Pull the bulb from the socket and replace by reversing the above steps.
-
Page 8: Hot Tub Care And Maintenance
Do not use an abrasive brush or cleaning agent, as it will scratch the ABS finish. If you have stubborn dirt or scum marks at the water line, use a hot tub cleaner and a scrub pad designed for use on plas- tic surfaces, which are available at your local hot tub dealership. -
Page 9: Winterizing
WINTERIZING If you live in an area where the danger of freezing exists, you must take extra precautions to insure that your hot tub will operate properly. If you plan to operate your hot tub throughout the winter, be sure that the thermostat is set to keep the water warm. If you intend on closing down your hot tub for the winter, you should follow the winterizing procedures listed below: Drain the hot tub as explained in the "Draining Your Hot Tub"... -
Page 10: Water Care
3 to 4 months or when the water clarity and cleanliness can no longer be maintained by chemical treatment. It is recommended that the total alkalinity of the hot tub water be kept from 80 to 100 parts per million (ppm) when... -
Page 11: Ozone
The ozonator is a unit that contains an ultra-violet light. When the unit is activated, ozone is generated which is drawn into the hot tub via the ozone jet. The ozone gas appears as tiny bubbles that come from the ozone jet which is located near the front of the hot tub. -
Page 12: Gfci Load Center Wiring
The white neutral wire from the back of the GFCI MUST be connected to an incoming line neutral. The internal mechanism of the GFCI requires this neutral connection. The GFCI will not work without it. Use a 50 amp 240 volt 4-wire GFCI circuit breaker for all Shoreline Leisure Products™ hot tub 240 volt models. IMPORTANT NOTE:... -
Page 13: Troubleshooting
Check for loose fasteners on the equipment module. • Make sure hot tub is not touching or rubbing against anything such as a deck rail, house, etc. • Make sure that the hot tub has been installed on a properly supported surface. -
Page 14: Thank You
Thank You! The employees of GPM Industries would like to extend their sincere thanks to you for purchasing a Shoreline Leisure Products™ hot tub. We hope that you, your family, and friends will experience many enjoyable years of fun and relaxation in your new hot tub. -
Page 15: Hot Tub And Dealer Information
Please fill in the following information, it will be very important should you ever have questions or concerns regarding your hot tub. Your Shoreline Leisure Products™ Dealer Dealership ___________________________________________________ Address ___________________________________________________ City __________________________ State _______ ZIP _________ Phone ___________________ Fax ____________________________... -
Page 16: Warranty
ACTS INVALIDATING WARRANTY. This warranty is void if the GPM hot tub has been subject to alteration, misuse or abuse, or if any repairs on the hot tub are attempted by anyone other than an authorized representative of GPM. Alteration shall include but is not limited to any component or plumbing change, electrical conversion, or the addition of any non-approved sanitation or water purification device or heating system which contributes to a component or unit failure or unsafe operation system.
Need help?
Do you have a question about the Hot Tub and is the answer not in the manual?
Questions and answers