Table Of Contents; Design Information; Product Clearances; Advance Planning - GE Monogram ZVC30LSS Installation Instructions Manual
30", 36" and 48" custom hood insert
Hide thumbs
Also See for Monogram ZVC30LSS:
- Installation instructions manual (21 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (16 pages)
Table of Contents
Advertisement
CONTENTS
Product Clearances ..........................................................................4
Product Dimensions ....................................................................5-7
Advance Planning ............................................................................8
Remote Mounting of the Control (Wired)..............................8
Power Supply ......................................................................................8
Duct Fittings ...................................................................................... 9
Tools and Materials Required ....................................................10
Remove the Packaging ................................................................10
Parts Provided ..................................................................................11
Ductwork, Wiring Locations ......................................................12
Construct Ceiling Support ..........................................................13
Remote Mounting of the Control (Wired)......................14-15
PRODUCT CLEARANCES
The vent hood and liner assembly must be installed
30" minimum and 36" maximum above the cooking
NOTE: Installation height should be measured
from the cooking surface to the bottom edge
of the metal hood liner or cabinet surface.
NOTE: UL requires any combustible surface to be
a minimum of 30" above the cooking surface.
•This hood must be vented to the outdoors.
•This hood may be mounted onto a wall or installed
over an island.
•This hood can be installed over any Monogram
electric/gas cooktop or Monogram Professional
cooktop or range of equivalent width.
Design Information
Step 1, Install Hood Liner ............................................................16
Step 2, Connect Electrical............................................................17
Step 3, Install Insert Sleeve ........................................................18
Step 4, Install Damper Plate ......................................................19
Step 5, Install Blower Motor........................................................20
Step 6, Connect Wiring Harness ..............................................20
Step 7, Install Filters ......................................................................21
Step 8, Finalize Installation ........................................................21
4
30" min.*
36" max.*
36" min.
Advertisement
Table of Contents
