Bosch Dishwasher Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Bosch Manuals
  4. Dishwasher
  5. DISHWASHER
  6. Installation instructions manual

Bosch Dishwasher Installation Instructions Manual

Dishwasher
Hide thumbs Also See for Dishwasher:
Table of Contents

Advertisement

Quick Links

See also: Instructions for Use Manual , Instruction and Installation Manual
YOUR LIFE. OUR INSPIRATION.
Dishwasher Installation Instructions
Instructions d'installation du lave-vaisselle
Instrucciones de instalación para lavavajillas
On/Off
Power
Use and Care Manual located on reverse side
Tourner le guide pour les instructions d'utilisation et d'entretien
Voltee el manual para encontrar las instrucciones de uso y cuidado
Cycle Countdown
Refill
Power
Scrub
Regular
Delicate/
Quick
Rinse
Wash
Econo
Rinse
Scrub
Wash
Wash
& Hold
Plus
Agent
Top
Delay
Rack
Start
Hours
Only
Cancel
Drain
9000089901 (8506)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Dishwasher and is the answer not in the manual?

Questions and answers

Tom Russell
March 31, 2025

How do you reinstall the various levels including the utensil drawer

0
1 comments:
Mr. Anderson
March 31, 2025

To reinstall the utensil (cutlery) drawer and other levels in a Bosch dishwasher:

1. Install the new cutlery drawer rail:
- Slide the new rail onto the roller.
- Push it onto the second roller using the same method on both sides.

2. Reattach the cutlery drawer:
- Align the drawer with the rails.
- Slide it in until it clicks into place.

3. Reinstall the upper dish rack:
- Lift and align the upper rack with the side rails.
- Lower it to engage the rollers, then slide it fully in.

Each level should smoothly glide into place on the corresponding rails and rollers.

This answer is automatically generated

0

Related Manuals for Bosch Dishwasher

Summary of Contents for Bosch Dishwasher

  • Page 1 YOUR LIFE. OUR INSPIRATION. Dishwasher Installation Instructions Instructions d’installation du lave-vaisselle Instrucciones de instalación para lavavajillas Cycle Countdown Refill On/Off Power Scrub Regular Delicate/ Quick Rinse Wash Econo Rinse Scrub Wash Wash & Hold Plus Agent Delay Rack Start Power...

  • Page 3: Table Of Contents

    The dishwasher must be installed by a qualified • NEW INSTALLATION - If the dishwasher is a service technician. new installation, most of the work must be done • In addition to these instructions, the dishwasher before the dishwasher is moved into place.

  • Page 4: Tools Needed

    Electrical Supply Cable - Minimum #14 AWG, 2 conductor, 1 ground, insulated copper conductors rated 75°C or higher. Hot Water Supply Line - Minimum 3/8” O.D. copper tubing or metal braided dishwasher supply line. Shut-off valve and fittings appropriate for hot water supply line (copper tubing/ compression fitting, or braided hose).

  • Page 5: Materials Supplied

    MATERIALS SUPPLIED Accessory Parts Supplied Accessory parts for your dishwasher come in one or more plastic bags that are outlined below. NOTE: Make sure you save all the bags until you have completed your installation. NOTE: Always use the supplied or recommended hardware.

  • Page 6: Enclosure Preparation

    For proper dishwasher operation and appearance, ensure that the enclosure is square and has the dimensions shown in Figure 1. If the dishwasher is to be installed in a corner, make sure that there is adequate clearance to open the door. See Figure 2.

  • Page 7: Electrical Preparation

    The customer has the responsibility of ensuring that the dishwasher electrical installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for an electrical supply of 120V, 3" - 4" 60 Hz, AC, connected to a dishwasher-dedicated,...

  • Page 8: Plumbing Preparation

    Water may also be supplied to the dishwasher by using a stainless steel braided hose approved for dishwasher use. Check with your local plumbing supply sources for the proper hose and 90°...

  • Page 9: Dishwasher Preparation

    PLUMBING PREPARATION (continued) Air Gap Drain Plumbing Under Sink Drain Connection If the dishwasher is to drain either directly into the household drain plumbing or through an air gap, install a Y-branch y-branch tailpiece under the sink as shown in Figure 7.
  • Page 10 Regular Toe Panel The toe panel is loosely attached with tape. Remove the Panel tape and pull the toe panel away from the dishwasher. Set the toe panel aside. It will be reinstalled later. Figure 12 Plastic Base Access Panel and Toe Panel (SHY66C,...

  • Page 11: Door Panel Installation

    25” accessory panel kit, install the panel prior to sliding the 1/4” max. (636 mm) (6 mm) dishwasher into place. The panel dimensions are shown in Figure 16. 23-1/16” SHI Models - Panel Installation (586 mm) SHI models come with additional mounting hardware and a template sheet with installation instructions.

  • Page 12: Placing The Dishwasher

    2 Position the dishwasher close enough to the enclosure so that you can run the dishwasher drain hose to the 14" (355mm) under sink drain connection. Make certain that the hot water supply line and the electrical supply cable are in 21"...

  • Page 13: Drain Hose Connection

    Plumbing Preparation section of this manual. Figure 24 Figure 25 NOTE: If the dishwasher drain hose is to be connected to a disposer dishwasher drain connection, remove the plug from the disposer’s dishwasher drain connection. Use the supplied Rubber Drain Hose Adaptor and Drain Hose Clamps to connect the dishwasher drain hose to the plumbing drain connection.

  • Page 14: Hot Water Connection

    • Be sure to use pipe thread compound or Teflon tape to seal the connection when required. • Before connecting the copper hot water supply line to the dishwasher, flush it with hot water to clear any foreign material. • Turn on the water supply to check for leaks after making connections.

  • Page 15: Electrical Connection

    Make sure that the dishwasher is connected to a suitable ground in compliance with all local codes or, in the absence of a Outer Wire...

  • Page 16: Door Tension Adjustment

    Figure 30. 5 Using the supplied wire nuts, connect the electrical supply wires to the dishwasher’s wires, black to black, white to white, and green or bare. Make certain that the insulated wires show no bare wire from the bottoms of the wire nuts.

  • Page 17: Base And Toe Panel

    Hydrogen gas is explosive. Before filling a dishwasher from a system that has been off for weeks, run the water from a nearby faucet in a well ventilated area until there is no sound or evidence of gas.

  • Page 18: Customer Service

    Your Bosch dishwasher requires no special care other than that described in the Care and Cleaning section of the Use and Care Manual. If you are having a problem with your dishwasher, before calling for service please refer to the Self- Help section of the Use and Care Manual.
  • Page 20 © BSH Home Appliances Corporation 2005 • Litho U.S.A. 07/04 90 00 08 99 01 (8506)

This manual is also suitable for:

Shy66cShx99aShe66cShe99cShx57c

Table of Contents

Save PDF