Kyocera FS-1025MFP Operation Manual page 76

No. Item
1 Host name
2 LAN interface
3 TCP/IP
4 SNMP
SNMP Traps Tab
Note The SNMP Traps tab only appears for the FS-1025MFP, FS-1125MFP and FS-1325MFP connected by
network connection.
No. Item
1 Trap Recipient
Description
Enter the host name of the machine.
MAX characters: 16
Select the type of LAN interface installed on the machine.
You can also select check boxes for available port types that the machine uses for
communication: LPD setting, Raw port, WSD print.
Value: Auto, 10Base-half, 10Base-full, 100Base-half, 100Base-full
Select the check box to enable the DHCP protocol. Enter the IP address, subnet
mask, and Default gateway values.
Select the check box to enable the SNMP protocol, and then select SNMP protocol
options. The SNMP protocol is used for providing and transferring management
information within the network environment. Read community and Write community
can have up to 16 characters. The default community is public. Type sysContact,
sysName, and sysLocation information up to 32 characters. Select Enable
authentication to activate machine authentication.
1
Description
You can select SNMP trap settings for 1 or 2 IP addresses.
Should an error occur, such as Add paper, the machine automatically generates a
trap. The trap sends an error message to one or two predetermined trap recipients.
The trap server is the SNMP trap packet receiver which runs in the application. The
default community is public.
For each IP address, select the Trap Recipient check box, type the name of the trap
community and IP address, and select from available events.
2-56
Preparation