Connecting The Headphones; Connecting An External Gps Antenna; First-Time Setup - Silvercrest PNA-E3510 User Manual And Service Information

English

Connecting the Headphones

Plug the supplied earphones [page 63, item 5] into the
headphones connector receptacle [page 71, item 6] of your
navigation device. Only use the supplied headphones.

Connecting an External GPS Antenna

If required, you can connect a conventional external GPS
antenna to your navigation device. This might be necessary
when using the device in a vehicle with a vertical windshield
(such as a truck or bus) obstructing the sight to the sky. Also,
some modern vehicles have a metallised windshield causing
a shield effect to the GPS signals.
The external antenna must have an SMB connector in order
to connect it to the corresponding receptacle [page 71, item
10] on the navigation device.
The device will receive the signals from the additional
antenna automatically: no further settings are required.
78

First-Time Setup

Prior to using the device for the first time, charge the
!
battery completely. The device can also charge the
battery while it is powered off.
1. Use a thin object (e.g. a clip) to slide the main power
switch [page 71, item 8] of the device into the On
position.
2. The manufacturer's logo and a loading bar will appear
for a few moments. After this, the message "For driving
safety, do not adjust the setting or operate this device
while driving" will be shown.
3. Confirm the setting by tapping this button:
Navigation Device PNA-E3510