Installation For The Apple Macintosh; Choosing A Scsi Id Number - AGFA Horizon Ultra Scanner Owner's Manual

Figure 2-1
Changing the SCSI ID number
On an Apple Macintosh, you can use the SCSI ID checker software
utility delivered with the scanner (see next page).
3. Use a screwdriver to set the desired SCSI ID on the switch at the
rear of the scanner.

Installation for the Apple Macintosh

This section shows you how to set up your Horizon Ultra scanner with
your Apple Macintosh computer. You must first choose and set a SCSI
ID number, then connect the scanner to your Apple Macintosh, and
finally test the connection.

Choosing a SCSI ID number

Before you connect your Horizon Ultra scanner to your Macintosh,
you have to find out which SCSI ID numbers are already assigned and
which numbers are free. To do this, you can use the Apple Macintosh
utility 'SCSI ID Checker'. You will find this utility on the Apple
Macintosh scanner software diskette.
1. Copy the SCSI ID Checker to your Apple Macintosh computer.
2. Open the SCSI ID Checker.
A dialog box appears with a list of the SCSI ID numbers that are
free in your Apple Macintosh computer.
Chapter 2 — Installing the scanner 25