Advertisement
Quick Links
Point of Use Water Heater
Installation & Instruction Manual
These instructions should be read in full before commencing the installation.
We recommend that the installation should only be carried out by a suitably qualified
person.
The Redring WS7-EcoT heater is an open outlet, thermal storage water heater for use
with Redring recommended fittings for one outlet only.
It operates on the displacement principle i.e. when cold water is admitted into the
bottom of the tank, hot water flows out through the outlet.
Installation
We recommend that this unit should be installed in the following order:
1. Fit wall bracket.
2. Fit mains electrical cable to the unit.
3. Fit heater to the wall.
4. Connect plumbing to the unit.
5. Replace the front cover.
6. Fill the unit with water and check for leaks.
7. Connect mains electrical cable to the fixed wiring.
8. Set the weekly mechanical timer.
9. Turn unit on and check operation.
10. Demonstrate operation to user.
Please Note:-
When removing the front cover, we recommend that you first remove the two top fixing
screws, but only LOOSEN the two bottom screws.
This will aid when replacing the front cover during installation.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS
Full details of terms and conditions are available on request from: -
(INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL
CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY
HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE
APPLIED ENERGY PRODUCTS LIMITED,
OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
MORLEY WAY, PETERBOROUGH PE2 9JJ
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY
TEL +44 (0) 844 372 7750 / FAX: +44 (0) 844 372 7760
DO NOT PLAY WITH THE APPLIANCE.
Website: www.applied-energy.com
(A4 Leaflet No. 578-2018-12a)
8
Advertisement
Related Manuals for Redring WS7-EcoT
Summary of Contents for Redring WS7-EcoT
- Page 1 We recommend that the installation should only be carried out by a suitably qualified person. The Redring WS7-EcoT heater is an open outlet, thermal storage water heater for use with Redring recommended fittings for one outlet only. It operates on the displacement principle i.e. when cold water is admitted into the bottom of the tank, hot water flows out through the outlet.
- Page 2 The bottom of the heater should be approximately 350mm above the top of the sink. Common Spare Parts and Recommended Accessories can be supplied from Redring Sales Hotline (RING) 0844 372 7766 or (FAX) 0844 372 7767 The outlet should be at least 13mm above the maximum possible water level for any unit that is to be filled from the heater.
- Page 3 If the unit is to be mounted below sink level, it MUST be connected to the special open This gives very hot water, which can be mixed with cold water to produce quantities outlet Monoblock Mixer Tap as recommended by Redring (see page 7). of usable water greater than the actual capacity of the heater.
- Page 4 The minimum selectable “ON” period is 2 hours and 20 minutes. A major benefit of the Redring WS7-EcoT heater is the energy saving possibilities of 2. Offer up the front cover to the main body, aim to fit the mechanical programmer controllability and the facility in a commercial installation to set a programme to cover a through the bezel keeping the front cover square to the wall.
Need help?
Do you have a question about the WS7-EcoT and is the answer not in the manual?
Questions and answers